12/30248593 DC : 0

Superseded

BS ISO 14577-2 - METALLIC MATERIALS - INSTRUMENTED INDENTATION TEST FOR HARDNESS AND MATERIALS PARAMETERS - PART 2: VERIFICATION AND CALIBRATION OF TESTING MACHINES

Available format(s)

Hardcopy , PDF

Superseded date

31-07-2015

Language(s)

English

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 General conditions
4 Calibration and direct verification
5 Indirect verification
6 Intervals between calibrations and verifications
7 Verification report/Calibration certificate
Annex A (informative) - Example of an indenter
        holder
Annex B (normative) - Procedures for determination
        of indenter area function
Annex C (informative) - Examples for the documentation
        of the results of indirect verification
Annex D (normative) - Frame compliance calibration
        procedure
Bibliography

BS ISO 14577-2

Committee	ISE/101/5
DocumentType	Draft
Pages	34
PublisherName	British Standards Institution
Status	Superseded
SupersededBy	BS EN ISO 14577-2:2015

ISO/IEC 17025:2005	General requirements for the competence of testing and calibration laboratories
ISO 14577-4:2016	Metallic materials Instrumented indentation test for hardness and materials parameters Part 4: Test method for metallic and non-metallic coatings
ISO 6508-2:2015	Metallic materials — Rockwell hardness test — Part 2: Verification and calibration of testing machines and indenters
ISO 376:2011	Metallic materials — Calibration of force-proving instruments used for the verification of uniaxial testing machines
ISO 14577-3:2015	Metallic materials Instrumented indentation test for hardness and materials parameters Part 3: Calibration of reference blocks
ISO 3878:1983	Hardmetals — Vickers hardness test
ISO/IEC Guide 98-3:2008	Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995)