14/30253068 DC : 0

Superseded

View Superseded by

BS EN ISO 4892-1 - PLASTICS - METHODS OF EXPOSURE TO LABORATORY LIGHT SOURCES - PART 1: GENERAL GUIDANCE

Available format(s)

Hardcopy , PDF

Superseded date

31-05-2016

Language(s)

English

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Requirements for laboratory exposure devices
6 Test specimens
7 Test conditions and procedure
8 Periods of exposure and evaluation of test results
9 Test report
Annex A (normative) - Procedures for measuring
        the irradiance uniformity in the specimen
        exposure area
Annex B (informative) - Factors that decrease
        the degree of correlation between artificial
        accelerated weathering or artificial
        accelerated irradiation exposures and
        actual-use exposures
Annex C (informative) - Solar spectral irradiance
        standards for daylight
Bibliography

BS EN ISO 4892-1.

Committee	PRI/21
DocumentType	Draft
Pages	32
PublisherName	British Standards Institution
Status	Superseded
SupersededBy	BS EN ISO 4892-1:2016

ISO 293:2004	Plastics — Compression moulding of test specimens of thermoplastic materials
ISO 3167:2014	Plastics Multipurpose test specimens
ISO 294-3:2002	Plastics Injection moulding of test specimens of thermoplastic materials Part 3: Small plates
ISO 295:2004	Plastics — Compression moulding of test specimens of thermosetting materials
ISO 294-2:1996	Plastics Injection moulding of test specimens of thermoplastic materials Part 2: Small tensile bars
ISO 4892-3:2016	Plastics Methods of exposure to laboratory light sources Part 3: Fluorescent UV lamps
ISO 4582:2017	Plastics — Determination of changes in colour and variations in properties after exposure to glass-filtered solar radiation, natural weathering or laboratory radiation sources
ISO 4892-4:2013	Plastics — Methods of exposure to laboratory light sources — Part 4: Open-flame carbon-arc lamps
ISO 4892-2:2013	Plastics — Methods of exposure to laboratory light sources — Part 2: Xenon-arc lamps
ISO 294-1:2017	Plastics — Injection moulding of test specimens of thermoplastic materials — Part 1: General principles, and moulding of multipurpose and bar test specimens
ISO 2818:1994	Plastics — Preparation of test specimens by machining
ISO 9370:2017	Plastics — Instrumental determination of radiant exposure in weathering tests — General guidance and basic test method