BS ISO 1206 - ROLLING BEARINGS - NEEDLE ROLLER BEARINGS WITH MACHINED RINGS - BOUNDARY DIMENSIONS, GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) AND TOLERANCE VALUES

Available format(s)

Hardcopy , PDF

Language(s)

English

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Nominal boundary and chamfer dimensions
6 Tolerances
7 Radial internal clearance
Annex A (informative) - Tolerances for shaft
        raceways for needle roller bearings without
        inner ring
Annex B (informative) - Symbols and terms as
        given in ISO 1206:2001 in relation to
         descriptions given in this International Standard
Bibliography

BS ISO 1206.

Committee	MCE/7
DocumentType	Draft
Pages	24
PublisherName	British Standards Institution
Status	NA

ISO 2639:2002	Steels Determination and verification of the depth of carburized and hardened cases
ISO 8015:2011	Geometrical product specifications (GPS) Fundamentals Concepts, principles and rules
ISO 14638:2015	Geometrical product specifications (GPS) Matrix model
ISO 5459:2011	Geometrical product specifications (GPS) — Geometrical tolerancing — Datums and datum systems
ISO/TS 17863:2013	Geometrical product specification (GPS) Tolerancing of moveable assemblies
ISO 1101:2017	Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out
ISO 5593:1997	Rolling bearings Vocabulary
ISO 14253-1:2017	Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications
ISO 582:1995	Rolling bearings — Chamfer dimensions — Maximum values
ISO 1132-1:2000	Rolling bearings — Tolerances — Part 1: Terms and definitions
ISO 5753-1:2009	Rolling bearings Internal clearance Part 1: Radial internal clearance for radial bearings
ISO 286-1:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 1: Basis of tolerances, deviations and fits
ISO 15241:2012	Rolling bearings — Symbols for physical quantities
ISO 286-2:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
ISO 14405-1:2016	Geometrical product specifications (GPS) — Dimensional tolerancing — Part 1: Linear sizes
ISO 14253-2:2011	Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 2: Guidance for the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification