BS EN 60331-1 - TESTS FOR ELECTRIC CABLES UNDER FIRE CONDITIONS - CIRCUIT INTEGRITY - PART 1: TEST METHOD FOR FIRE WITH SHOCK AT A TEMPERATURE OF AT LEAST 830 DEGREES C FOR CABLES OF RATED VOLTAGE UP TO AND INCLUDING 0,6/1,0 KV AND WITH AN OVERALL DIAMETER EXCEEDING 20 MM

Available format(s)

Hardcopy , PDF

Language(s)

English

Publisher

British Standards Institution

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Test conditions
5 Test apparatus
6 Test specimen (Electric power and control
   cables with rated voltage up to and including
   600/1000 V)
7 Test procedure (Electric power and control
   cables with rated voltage up to and including
   600/1000 V)
8 Performance requirements (Electric power and
   control cables with rated voltage up to and including
   600/1000 V)
9 Retest procedure
10 Test report (Electric power and control cables with
  rated voltage up to and including 600/1000 V)
11 Cable marking
Annex A (normative) - Verification procedure for the
        source of heat
Annex B (informative) - Guidance on the choice of
        recommended test apparatus
Bibliography

BS EN 60331-1.

Committee	GEL/20/18
DocumentType	Draft
Pages	31
PublisherName	British Standards Institution
Status	NA

IEC 60331-2:2009	Tests for electric cables under fire conditions - Circuit integrity - Part 2: Test method for fire with shock at a temperature of at least 830 °C for cables of rated voltage up to and including 0,6/1,0 kV and with an overall diameter not exceeding 20 mm
IEC 60269-3:2010+AMD1:2013 CSV	Low-voltage fuses - Part 3: Supplementary requirements for fuses foruse by unskilled persons (fuses mainly for household or similar applications) - Examples of standardized systems of fuses A to F
IEC GUIDE 104:2010	The preparation of safety publications and the use of basic safety publications and group safety publications
IEC 60584-1:2013	Thermocouples - Part 1: EMF specifications and tolerances
IEC 61034-1:2005+AMD1:2013 CSV	Measurement of smoke density of cables burning under defined conditions - Part 1: Test apparatus