AS 1443-1994

1 - AS 1443-1994 CARBON STEELS AND CARBON-MANGANESE STEELS - COLD-FINISHED BARS
4 - PREFACE
5 - CONTENTS
6 - 1 SCOPE
6 - 2 REFERENCED DOCUMENTS
7 - 3 DEFINITIONS
7 - 3.1 Bars
7 - 3.2 Fully killed steel
7 - 3.3 Merchant quality steel
7 - 3.4 Test batch
7 - 3.5 Test piece
7 - 3.6 Test sample
7 - 3.7 Test specimen
7 - 4 DESIGNATION
7 - 4.1 General
8 - 4.2 Steels supplied to chemical composition only
8 - 4.3 Steels supplied to chemical composition and mechanical properties
8 - 4.4 Austenitic grain size
9 - 5 CONDITION OF STEEL ON DELIVERY
9 - 5.1 General
9 - 5.2 Steel supplied to chemical composition
9 - 5.3 Steels supplied to chemical composition and mechanical properties
9 - 6 MATERIALS
9 - 6.1 Chemical composition
9 - 6.2 Tensile test requirements
9 - 7 FREEDOM FROM DEFECTS
9 - 7.1 General
10 - 7.2 Bright bars
10 - 7.3 Cold-sized or peeled bars
10 - 8 DIMENSIONAL TOLERANCES
10 - 9 TENSILE TEST
10 - 9.1 Condition of test samples
10 - 9.2 Location and preparation of test pieces
11 - 9.3 Method of test
11 - 10 ROUNDING OF TEST RESULT VALUES
11 - 10.1 General
11 - 10.2 Tensile test results
11 - 11 MARKING
18 - APPENDIX A - PURCHASING GUIDELINES
18 - A1 GENERAL
18 - A2 INFORMATION TO BE SUPPLIED BY THE PURCHASER
20 - APPENDIX B - MEANS FOR DEMONSTRATING COMPLIANCE WITH THIS STANDARD
20 - B1 SCOPE
20 - B2 STATISTICAL SAMPLING
20 - B3 PRODUCT CERTIFICATION
20 - B4 SUPPLIER’S QUALITY SYSTEM
21 - B5 OTHER MEANS OF ASSESSMENT
21 - B5.1 General
21 - B5.2 Sampling
21 - B5.3 Retesting
22 - APPENDIX C - REQUIREMENTS FOR MAXIMUM SURFACE IMPERFECTION DEPTH AND RECOMMENDED MACHINING ALLOWANCES

Specifies requirements for cold-finished carbon steel and carbon-manganese steel bars produced by cold drawing, cold-rolling, peeling, machining and polishing, precision grinding or cold sizing, to specified chemical composition only or to specified chemical composition and mechanical properties, intended for general engineering purposes.

This Standard specifies requirements for cold-finished carbon steel and carbon-manganese steel bars manufactured from hot-rolled bars and semifinished products (see AS 1442), for general engineering purposes. The Standard applies to steel supplied to specified chemical composition only or to specified chemical composition and mechanical properties. It permits the addition of elements such as boron and micro-alloying elements for the achievement of special properties.NOTES:1 Advice and recommendations on information that should be supplied by the purchaser at the time of enquiry and order are given in Appendix A.2 Alternative means for determining compliance with this Standard are given in Appendix B.

Under Revision see DR 03311 First published as AS G17-1966.Revised and redesignated AS 1443-1973.Second edition 1979.Third edition 1983.Fourth edition 1994. First published as AS G17-1966. Revised and redesignated AS 1443-1973. Second edition 1979. Third edition 1983. Fourth edition 1994.