We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • AS 2005.10-1988

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    Low voltage fuses - Fuses with enclosed fuse-links - General requirements

    Available format(s):  Hardcopy, PDF 1 User, PDF 3 Users, PDF 5 Users, PDF 9 Users

    Superseded date:  30-06-2017

    Language(s): 

    Published date:  01-01-1988

    Publisher:  Standards Australia

    Add to Watchlist

    Add To Cart

    Abstract - (Show below) - (Hide below)

    Specifies requirements for fuses incorporating enclosed fuse-links, with breaking capacities not less than 6 kA, intended for the protection of a.c. power-frequency circuits of nominal voltages not exceeding 1000 volt or d.c. circuits of nominal voltages not exceeding 1500 V. It should also be applied to fuse-links for inclusion in fuse-switch combinations. Includes definitions, conditions for operation in service, characteristics, markings, standard conditions for construction and tests. It is structured to be closely aligned with IEC 269-1.

    Scope - (Show below) - (Hide below)

    Scope.This Standard is applicable to fuses incorporating enclosed current-limiting fuse-links with rated breaking capacities of not less than 6 kA, intended for protecting power-frequency a.c. circuits of nominal voltages not exceeding 1000 V or d.c. circuits of nominal voltages not exceeding 1500 V. Further Standards in the AS 2005 series cover supplementary requirements for such fuses intended for specific conditions of use or application. (See Note 4.)NOTES:1. The details of performance for 'a' fuse-links (see Clause 2.2.4) in d.c. circuits should be subject to agreement between the purchaser and the manufacturer.2. Modifications of, and supplements to, this Standard required for certain types of fuses for particular applications, e.g. certain fuses for rolling stock or fuses for high-frequency circuits, will be covered, if necessary, by separate Standards.3. This Standard does not apply to miniature fuses which are covered by IEC 127 and IEC 257.4. Further Standards in the AS 2005 series are in course of preparation and will be based on IEC 269-2, IEC 269-3 and IEC 269-4.Application.AS 2005.2 and AS 2005.3 may be read in conjunction with this Standard until superseded by the relevant new Standards in the AS 2005 series.Fuses with enclosed fuse-links shall comply with the requirements of this Standard when other Standards in this series of Standards are published (see Preface). Fuse-links intended to be included in fuse-switch combinations complying with AS 1775 should also comply with the requirements of this Standard.

    General Product Information - (Show below) - (Hide below)

    Committee EL-006
    Document Type Standard
    Publisher Standards Australia
    Status Superseded
    Superseded By
    Supersedes

    History - (Show below) - (Hide below)

    Under Revision see DR 99426 First published as AS 2005.1-1977.Second edition 1981.Revised and redesignated as AS 2005.10-1988. First published as AS 2005.1-1977. Second edition 1981. Revised and redesignated as AS 2005.10-1988.

    Standards Referencing This Book - (Show below) - (Hide below)

    AS 2005.30-1991 Low voltage fuses - Fuses with enclosed fuse-links - Supplementary requirements for fuses for use by unskilled persons (fuses mainly for household and similar applications)
    AS 3947.2-1997 Low-voltage switchgear and controlgear - Circuit-breakers
    AS 1418.14-1996 Cranes (including hoists and winches) Requirements for cranes subject to arduous working conditions
    AS 3124-2002 Approval and test specification for overhead line connector boxes (Reconfirmed 2020)
    AS/NZS 4898:1997 Approval and test specification - Circuit-breakers for overcurrent protection for household and similar installations
    AS/NZS 3112:2000 Approval and test specification - Plugs and socket-outlets
    AS/NZS 3947.1:1998 Low-voltage switchgear and controlgear General rules
    AS 3947.4.1-1995 Low-voltage switchgear and controlgear - Contactors and motor-starters - Electromechanical contactors and motor-starters
    AS 3947.1-1993 Low-voltage switchgear and controlgear General rules
    AS/NZS 2293.1:1995 Emergency evacuation lighting for buildings System design, installation and operation
    AS/NZS 2293.1:1998 Emergency evacuation lighting for buildings System design, installation and operation
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective