AS 2703-2008
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Vehicle loop detector sensors
Available format(s)
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
Superseded date
12-12-2022
Language(s)
English
Published date
17-12-2008
Publisher
Specifies requirements for the design, construction and performance of electronic sensing equipment used in traffic control and counting systems for the detection of vehicles. It applies primarily to detector sensors of the permanently installed type associated with road traffic signal installations.
This Standard specifies requirements for the design, construction and performance of vehicle loop detectors. These detectors may also be designed to operate with trams/light rail. The type of detectors covered in this Standard are independent, rack-mounted and integrated vehicle loop detectors.NOTE: See Appendix D for the information which should be supplied with an enquiry or order for vehicle loop detectors to this Standard.
| Committee |
LG-006
|
| DocumentType |
Standard
|
| ISBN |
0 7337 8984 6
|
| Pages |
38
|
| ProductNote |
Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
Originated as AS 2703-1984.Previous edition 1987.Third edition 2008. Originated as AS 2703-1984. Previous edition 1987. Third edition 2008.
| AS/NZS 61000.2.2:2003 | Electromagnetic compatibility (EMC) Environment - Compatibility levels for low-frequency conducted disturbances and signalling in public low-voltage power supply systems (Reconfirmed 2013) |
| AS/NZS 61558.2.6:2001 | Safety of power transformers, power supply units and similar Particular requirements for safety isolating transformers for general use (IEC 61558-2-6:1997, MOD) |
| AS/NZS 61000.4.2:2002 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Electrostatic discharge immunity test |
| AS/NZS 61000.4.3:2006 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Radiated, radio-frequency, electromagnetic field immunity test |
| AS 1199.4-2003 | Sampling procedures for inspection by attributes Procedures for assessment of declared quality levels (Reconfirmed 2016) |
| AS/NZS 61000.2.3:1999 | Electromagnetic compatibility (EMC) Environment - Description of the environment - Radiated and non-network-frequency-related conducted phenomena (Reconfirmed 2016) |
| AS/NZS 61558.2.8:2001 | Safety of power transformers, power supply units and similar Particular requirements for bell and chime transformers (IEC 61558-2-8:1998, IDT) |
| AS/NZS 61558.2.15:2001 | Safety of power transformers, power supply units and similar Particular requirements for isolating transformers for the supply of medical locations (IEC 61558-2-15:1999, MOD) |
| AS/NZS 61000.2.5:1999 | Electromagnetic compatibility (EMC) Environment - Classification of electromagnetic environments (Reconfirmed 2016) |
| AS/NZS 61000.4.34:2007 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Voltage dips, short interruptions and voltage variations immunity tests for equipment with input current more than 16 A per phase (IEC 61000-4-34, Ed. 1.0 (2005) MOD) |
| AS/NZS 61000.4.5:2006 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Surge immunity test |
| AS/NZS CISPR 14.1:2003 | Electromagnetic compatibility - Requirements for household appliances, electric tools and similar apparatus Emission |
| AS/NZS 61000.6.3:2007 | Electromagnetic compatibility (EMC) Generic standards - Emission standard for residential, commercial and light-industrial environments |
| AS/NZS 60320.1:2004 | Appliance couplers for household and similar general purposes General requirements (IEC 60320-1, Ed. 2.0 (2001) MOD) |
| AS/NZS 3100:2002 | Approval and test specification - General requirements for electrical equipment |
| AS/NZS 61000.6.4:2007 | Electromagnetic compatibility (EMC) Generic standards - Emission standard for industrial environments |
| AS/NZS 61000.6.1:2006 | Electromagnetic compatibility (EMC) Generic standards - Immunity for residential, commercial and light industrial environments (Reconfirmed 2016) |
| AS/NZS 61000.3.5:1998 | Electromagnetic compatibility (EMC) Limits - Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16 A |
| AS/NZS 61558.2.4:2001 | Safety of power transformers, power supply units and similar Particular requirements for isolating transformers for general use (IEC 61558-2-4:1997, MOD) |
| AS/NZS 61000.4.4:2006 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Electrical fast transient/burst immunity test |
| AS 1199.3-2003 | Sampling procedures for inspection by attributes Skip-lot sampling procedures (Reconfirmed 2016) |
| AS/NZS 3000:2007 | Electrical installations (known as the Australian/New Zealand Wiring Rules) |
| AS/NZS 61000.1.1:2000 | Electromagnetic compatibility (EMC) General - Application and interpretation of fundamental definitions and terms (Reconfirmed 2016) |
| AS/NZS 61000.3.7:2001 | Electromagnetic compatibility (EMC) Limits - Assessment of emission limits for fluctuating loads in MV and HV power systems (IEC 61000-3-7:1996, MOD) |
| AS/NZS 61000.6.2:2006 | Electromagnetic compatibility (EMC) General standards - Immunity for industrial environments (Reconfirmed 2016) |
| AS/NZS 3191:2008 | Electric flexible cords (Reconfirmed 2019) |
| AS/NZS 61000.4.15:2005 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Flickermeter - Function and design specifications |
| AS/NZS 61558.2.5:2003 | Safety of power transformers, power supply units and similar Particular requirements for shaver transformers (IEC 61558-2-5:1997, MOD) |
| AS/NZS 61558.2.3:2001 | Safety of power transformers, power supply units and similar devices Particular requirements for ignition transformers for gas and oil burners (IEC 61558-2-3:1999, IDT) |
| AS 1199.1-2003 | Sampling procedures for inspection by attributes Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection (Reconfirmed 2016) |
| AS/NZS 61558.2.17:2001 | Safety of power transformers, power supply units and similar Particular requirements for transformers for switch mode power supplies (IEC 61558-2-17:1997, MOD) |
| AS/NZS 61000.4.27:2006 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Unbalance, immunity test |
| AS/NZS 61000.4.16:2002 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Test for immunity to conducted common mode disturbances in the frequency range 0 Hz to 150 kHz (Reconfirmed 2013) |
| AS 1199.2-2003 | Sampling procedures for inspection by attributes Sampling plans indexed by limiting quality (LQ) for isolated lot inspection (Reconfirmed 2016) |
| AS/NZS 61558.1:2000 | Safety of power transformers, power supply units and similar General requirements and tests (IEC 61558-1 Ed 1.1, MOD) |
| AS/NZS 61000.4.30:2007 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Power quality measurement methods |
| AS/NZS 61000.2.12:2003 | Electromagnetic compatibility (EMC) Environment - Compatibility levels for low-frequency conducted disturbances and signalling in public medium-voltage power supply systems (Reconfirmed 2013) |
| AS/NZS 2276.2:1998 | Cables for traffic signal installations Feeder cable for vehicle detectors |
| AS/NZS 61000.3.3:2006 | Electromagnetic compatibility (EMC) Limits - Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current per phase and not subject to conditional connection |
| AS/NZS 61000.4.6:2006 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Immunity to conducted disturbances, induced by radio-frequency fields |
| AS/NZS 61000.3.4:2007 | Electromagnetic compatibility (EMC) Limits - Limitation of emission of harmonic currents in low-voltage power supply systems for equipment with rated current greater than 75 A (Reconfirmed 2018) |
| AS/NZS 61000.4.11:2005 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Voltage dips, short interruptions and voltage variations immunity tests (IEC 61000-4-11, Ed. 2.0 (2004) MOD) (Reconfirmed 2016) |
| AS/NZS 61000.3.12:2006 | Electromagnetic compatibility (EMC) Limits - Limits for harmonic currents produced by equipment connected to public low-voltage systems with input current greater than 16 A and less than or equal to 75 A per phase |
| AS/NZS 61558.2.9:2003 | Safety of power transformers, power supply units and similar products Particular requirements for transformers for class III handlamps for tungsten filament lamps (IEC 61558-2-9:2002, MOD) |
| AS/NZS 61000.4.8:2002 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Power frequency magnetic field immunity test |
| AS/NZS 61558.2.23:2001 | Safety of power transformers, power supply units and similar devices Particular requirements for transformers for construction sites (IEC 61558-2-23:2000, MOD) |
| AS/NZS 61000.3.11:2002 | Electromagnetic compatibility (EMC) Limits - Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems - Equipment with rated current less than or equal to 75 A and subject to conditional connection (Reconfirmed 2013) |
| AS 1199.0-2003 | Sampling procedures for inspection by attributes Introduction to the ISO 2859 attribute sampling system (Reconfirmed 2016) |
| AS/NZS 61000.4.7:2007 | Electromagnetic compatibility (EMC) Testing and measurement techniques - General guide on harmonics and interharmonics measurements and instrumentation, for power supply systems and equipment connected thereto |
| AS 2578.1-1983 | Traffic signal controllers - Physical and electrical compatibility |
| AS/NZS 61000.4.14:2007 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Voltage fluctuation immunity test |
| AS/NZS 61558.2.7:2008 | Safety of power transformers, power supplies, reactors and similar products Particular requirements and tests for transformers and power supplies for toys (Reconfirmed 2020) |
| AS/NZS 61558.1:2008 | Safety of Power Transformers, Power Supplies, Reactors and Similar Products General requirements and tests (IEC 61558-1 Ed 2, MOD) |
| AS/NZS 61000.3.6:2001 | Electromagnetic compatibility (EMC) Limits - Assessment of emission limits for distorting loads in MV and HV power systems (IEC 61000-3-6:1996, MOD) |
| AS/NZS 61000.4.13:2006 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Harmonics and interharmonics including mains signalling at a.c. power port, low frequency immunity tests |
| AS/NZS 61000.4.1:2006 | Electromagnetic compatibility (EMC) Testing and measurement techniques - Overview of IEC 61000-4 series |
| AS/NZS 61000.3.2:2007 | Electromagnetic compatibility (EMC) Limits - Limits for harmonic current emissions (equipment input current (16 A per phase) (IEC 61000-3-2, Ed. 3.0 (2005) MOD) |
| AS 2578-2009 | Traffic signal controllers |
$135.16
Including GST where applicable
AUD
CAD
CHF
CNY
DKK
EUR
GBP
HKD
IDR
INR
JPY
KRW
MXN
NOK
NZD
SEK
SGD
USD
ZAR
Hardcopy - English
PDF 1 User - English
PDF 3 Users - English
PDF 5 Users - English
PDF 9 Users - English
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.