1 - AS/NZS 61347.2.2:2007 Lamp controlgear Part 2.2: Particular requirements for d.c. or a.c. supplied electronic step-down convertors for filament lamps (IEC 61347-2-2, Ed. 1.2 (2006) MOD)
4 - PREFACE
7 - INTRODUCTION
6 - CONTENTS
9 - 1 Scope
9 - 2 Normative references
11 - 3 Definitions
12 - 4 General requirements
12 - 5 General notes on tests
13 - 6 Classification
13 - 7 Marking
13 - 7.1 Mandatory marking
13 - 7.2 Information to be provided if applicable
13 - 8 Protection against accidental contact with live parts
17 - 9 Terminals, cables and cords
17 - 10 Provisions for earthing
17 - 11 Moisture resistance and insulation
17 - 12 Electric strength
17 - 13 Thermal endurance test for windings
17 - 14 Fault conditions
17 - 15 Transformer heating
18 - 15.1 Normal operation
18 - 15.2 Abnormal operation
18 - 16 Abnormal conditions
19 - 17 Construction
19 - 18 Creepage distances and clearances
19 - 19 Screws, current- carrying parts and connections
19 - 20 Resistance to heat, fire and tracking
19 - 21 Resistance to corrosion
20 - Annex A (normative) Test to establish whether a conductive part is a live part which may cause an electric shock
20 - Annex B (normative) Particular requirements for thermally protected lamp controlgear
20 - Annex C (normative) Particular requirements for electronic lamp controlgear with means of protection against overheating
20 - Annex D (normative) Requirements for carrying out the heating tests of thermally protected lamp controlgear
20 - Annex E (normative) Use of constant S other than 4 500 in tw tests
20 - Annex F (normative) Draught-proof enclosure
21 - Annex G (informative) Explanation of the derivation of the values of pulse voltages
21 - Annex H (normative) Tests
22 - Annex I (normative) Particular additional requirements for independent SELV d.c. or a.c. supplied electronic step-down convertors for filament lamps