The objective of this Standard is to specify the apparatus and procedure for the determination of the potential corrosivity of gases evolved during the combustion of materials taken from electric or optical fibre cable constructions by measuring the acidity (pH) and conductivity of an aqueous solution resulting from the gases evolved during the combustion.

This part of IEC 60754 specifies the apparatus and procedure for the determination of the potential corrosivity of gases evolved during the combustion of materials taken from electric or optical fibre cable constructions by measuring the acidity (pH) and conductivity of an aqueous solution resulting from the gases evolved during the combustion.The general method specified in this standard is intended for the testing of individual components used in a cable construction. Formulae are given for the calculation of a weighted value for a combination of materials found in a specified cable. The use of this method will enable the verification of relevant requirements for either individual components or combined components of a cable construction stated in the appropriate cable specification.A simplified method is included for the testing of individual components where it is required only to demonstrate compliance with a stated performance requirement for quality control purposes.NOTE 1 The relevant cable standard should indicate which components of the cable should be tested, and which method of calculation (see Clause 8) should be used in the case of dispute.NOTE 2 This test method may be used to test materials to be used in cable manufacture, but a declaration of cable performance should not be made based on such a test.NOTE 3 For the purposes of this standard, the term “electric cable” covers all insulated metallic conductor cables used for the conveyance of energy or signals.

Originated in Australia as SAA Int 88003—1988.Final Australian edition AS 1660.5.4—1992.Jointly revised and designated AS/NZS 1660.5.4:1998.AS/NZS 1660.5.4:1998 revised and redesignated as AS/NZS IEC 60754.2:2017. Originated in Australia as SAA Int 88003-1988. Final Australian edition AS 1660.5.4-1992. Jointly revised and designated AS/NZS 1660.5.4:1998. AS/NZS 1660.5.4:1998 revised and redesignated as AS/NZS IEC 60754.2:2017. Originated in Australia as SAA Int 88003-1988. Final Australian edition AS 1660.5.4-1992. Jointly revised and designated AS/NZS 1660.5.4:1998. AS/NZS 1660.5.4:1998 revised and redesignated as AS/NZS IEC 60754.2:2017. Reissued incorporating Amendment No 1 (October 2021).