ASTM D 3094 : 2000 : R2010

Name: ASTM D 3094 : 2000 : R2010
Brand: ASTM
Price: 108.03 AUD

Superseded

View Superseded by

Standard Test Method for Seepage Rate of Aerosol Products

Available format(s)

Hardcopy , PDF

Superseded date

21-12-2023

Language(s)

English

Published date

01-10-2010

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 15.09, 2015 Describes the approximate mass loss due to valve seepage rate of aerosol products by the collection and measurement of gases seeping through the valve and into a special eudiometer tube, over a relatively short time period.

1.1 This test method covers the determination of approximate mass loss due to valve seepage rate of aerosol products by the collection and measurement of gases seeping through the valve and into a special eudiometer tube, over a relatively short time period.

1.2 It can be shown that the average refrigeration-filled aerosol product seeps to the extent of approximately 3.0 mL when the corresponding mass loss is 0.10 oz (2.9 cm³)/year. This figure is partially based on air content and is subject to variations according to filling conditions. This test method is not considered dependable when applied to pressure-filled, unpurged aerosol products.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee	D 10
DocumentType	Test Method
Pages	3
ProductNote	Reconfirmed 2010 Reconfirmed 2008 Reconfirmed 2016
PublisherName	American Society for Testing and Materials
Status	Superseded
SupersededBy	ASTM D 3094 : 2018
Supersedes	ASTM D 3094 : 2000 : R2005

ASTM D 1129 : 2013 : REDLINE	Standard Terminology Relating to Water
IEEE/ASTM SI_10-2010	American National Standard for Metric Practice
ASTM D 1253 : 2014 : REDLINE	Standard Test Method for Residual Chlorine in Water
ASTM D 1125 : 2014 : REDLINE	Standard Test Methods for Electrical Conductivity and Resistivity of Water (Withdrawn 2023)
ASTM D 4065 : 2012 : REDLINE	Standard Practice for Plastics: Dynamic Mechanical Properties: Determination and Report of Procedures
ASTM D 4000 : 2016 : REDLINE	Standard Classification System for Specifying Plastic Materials