ASTM D 5013 : 1989 : R2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Practices for Sampling Wastes from Pipes and Other Point Discharges
Hardcopy , PDF
11-11-2014
English
01-02-2009
1.1 Those practices provide guidance for obtaining samples of waste at discharge points from pipes, sluiceways, conduits, and conveyor belts. The following are included:
| Sections | |
| Practice A—Liquid or Slurry Discharges Practice B—Solid or Semisolid Discharges | 7 through 9 10 through 12 |
1.2 These practices are intended for situations in which there are no other applicable ASTM sampling methods (see Practices D 140 and D 75
1.3 These practices do not address flow and time-proportional samplers and other automatic sampling devices.
1.4 Samples are taken from a flowing waste stream or moving waste mass and, therefore, are descriptive only within a certain period. The length of the period for which a sample is descriptive will depend on the sampling frequency and compositing scheme.
1.5 It is recommended that these practices be used in conjunction with Guide D 4687
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 5 for more information.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.