ASTM D 5948 : 1996 : R2002 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Specification for Molding Compounds, Thermosetting
Hardcopy , PDF
11-11-2014
English
10-11-2002
1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.
1.2 ClassificationMolding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1and Annex A1-Annex A8).
| Resin |
| Phenolic, cellulose filled |
| Phenolic, mineral/glass filled |
| Melamine |
| Polyester |
| Diallyl iso-phthalate |
| Diallyl ortho-phthalate |
| Silicone |
| Epoxy |
Note 1—There is no equivalent ISO standard.
1.3 Order of Precedence—In the event of a conflict between the text of this specification and the references cited in Section (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
1.4 The values stated in SI units are to be considered standard.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.