ASTM D 6031/D6031M : 1996 : R2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
19-01-2024
English
09-11-2015
CONTAINED IN VOL. 04.09, 2015 Specifies collection and comparison of logs of thermalized-neutron counts and back-scattered gamma counts along horizontal or vertical air-filled access tubes.
1.1This test method covers collection and comparison of logs of thermalized-neutron counts and back-scattered gamma counts along horizontal or vertical air-filled access tubes.
1.2The in situ water content in mass per unit volume and the density in mass per unit volume of soil and rock at positions or in intervals along the length of an access tube are calculated by comparing the thermal neutron count rate and gamma count rates respectively to previously established calibration data.
1.3The values stated in either inch-pound units or SI units [presented in brackets] are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3.1The gravitational system of inch-pound units is used when dealing with inch-pound units. In this system, the pound (lbf) represents a unit of force (weight), while the unit for mass is slugs. The rationalized slug unit is not given, unless dynamic (F = ma) calculations are involved.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards, see Section 6.
| Committee |
D 18
|
| DevelopmentNote |
Supersedes ASTM D 6031. (10/2010)
|
| DocumentType |
Test Method
|
| Pages |
7
|
| ProductNote |
Reconfirmed 2015
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| ASTM D 2216 : 2005 | Standard Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass |
| ASTM D 5220 : 2002 | Standard Test Method for Water Content of Soil and Rock In-Place by the Neutron Depth Probe Method |
| ASTM D 4564 : 2008 | Standard Test Method for Density and Unit Weight of Soil in Place by the Sleeve Method |
| ASTM D 2937 : 2000 : EDT 1 | Standard Test Method for Density of Soil in Place by the Drive-Cylinder Method |
| ASTM D 3550 : 1984 : R1995 : EDT 1 | Standard Practice for Thick Wall, Ring-Lined, Split Barrel, Drive Sampling of Soils |
| ASTM D 1452 : 2009 | Standard Practice for Soil Exploration and Sampling by Auger Borings |
| ASTM D 1586 : 2008 : REV A | Standard Test Method for Standard Penetration Test (SPT) and Split-Barrel Sampling of Soils |
| ASTM D 5195 : 2008 | Standard Test Method for Density of Soil and Rock In-Place at Depths Below Surface by Nuclear Methods |
| ASTM D 2216 : 2010 | Standard Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass |
| ASTM D 1586 : 1999 | Standard Test Method for Penetration Test and Split-Barrel Sampling of Soils |
| ASTM D 1586 : 2008 | Standard Test Method for Standard Penetration Test (SPT) and Split-Barrel Sampling of Soils |
| ASTM D 2113 : 2014 | Standard Practice for Rock Core Drilling and Sampling of Rock for Site Exploration (Withdrawn 2023) |
| ASTM D 3017 : 2005 | Standard Test Method for Water Content of Soil and Rock in Place by Nuclear Methods (Shallow Depth) (Witthdrawn 2007) |
| ASTM D 1452 : 2007 : REV A | Standard Practice for Soil Investigation and Sampling by Auger Borings |
| ASTM D 1587 : 2008 : R2012 : EDT 1 | Standard Practice for Thin-Walled Tube Sampling of Soils for Geotechnical Purposes |
| ASTM D 2937 : 2017 | Standard Test Method for Density of Soil in Place by the Drive-Cylinder Method |
| ASTM D 5195 : 1991 : R1996 | Standard Test Method for Density of Soil and Rock In-Place at Depths Below the Surface by Nuclear Methods |
| ASTM D 5220 : 1992 : R1997 | Standard Test Method for Water Content of Soil and Rock In-Place by the Neutron Depth Probe Method |
| ASTM D 2922 : 1996 : EDT 1 | Standard Test Methods for Density of Soil and Soil-Aggregate in Place by Nuclear Methods (Shallow Depth) |
| ASTM D 5220 : 2014 : REDLINE | Standard Test Method for Water Mass per Unit Volume of Soil and Rock In-Place by the Neutron Depth Probe Method |
| ASTM D 5195 : 2021 | Standard Test Method for Density of Soil and Rock In-Place at Depths Below Surface by Nuclear Methods |
| ASTM D 4564 : 1993 | Standard Test Method for Density of Soil in Place by the Sleeve Method |
| ASTM D 2113 : 2014 : REDLINE | Standard Practice for Rock Core Drilling and Sampling of Rock for Site Exploration |
| ASTM D 1586 : 2011 | Standard Test Method for Standard Penetration Test (SPT) and Split-Barrel Sampling of Soils |
| ASTM D 3017 : 2001 | Standard Test Method for Water Content of Soil and Rock in Place by Nuclear Methods (Shallow Depth) |
| ASTM D 2922 : 2004 | Standard Test Methods for Density of Soil and Soil-Aggregate in Place by Nuclear Methods (Shallow Depth) |
| ASTM D 4564 : 2002 : REV A | Standard Test Method for Density of Soil in Place by the Sleeve Method |
| ASTM D 1587 : 2008 | Standard Practice for Thin-Walled Tube Sampling of Soils for Geotechnical Purposes |
| ASTM D 2922 : 2001 | Standard Test Methods for Density of Soil and Soil-Aggregate in Place by Nuclear Methods (Shallow Depth) |
| ASTM D 2937 : 2017 : EDT 2 | Standard Test Method for Density of Soil in Place by the Drive-Cylinder Method |
| ASTM D 4428/D4428M : 2014 | Standard Test Methods for Crosshole Seismic Testing (Withdrawn 2023) |
| ASTM D 4564 : 2002 | Standard Test Method for Density of Soil in Place by the Sleeve Method |
| ASTM D 2922 : 2005 | Standard Test Methods for Density of Soil and Soil-Aggregate in Place by Nuclear Methods (Shallow Depth) (Withdrawn 2007) |
| ASTM D 2937 : 2010 | Standard Test Method for Density of Soil in Place by the Drive-Cylinder Method |
| ASTM D 2216 : 2019 | Standard Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass |
| ASTM D 2937 : 2000 | Standard Test Method for Density of Soil in Place by the Drive-Cylinder Method |
| ASTM D 3550 : 2001 : R2007 | Standard Practice for Thick Wall, Ring-Lined, Split Barrel, Drive Sampling of Soils (Withdrawn 2016) |
| ASTM D 3017 : 2004 | Standard Test Method for Water Content of Soil and Rock in Place by Nuclear Methods (Shallow Depth) |
| ASTM D 2113 : 2006 | Standard Practice for Rock Core Drilling and Sampling of Rock for Site Investigation |
| ASTM D 2113 : 2008 | Standard Practice for Rock Core Drilling and Sampling of Rock for Site Investigation |
| ASTM D 2113 : 1999 | Standard Practice for Rock Core Drilling and Sampling of Rock for Site Investigation |
| ASTM D 4428/D4428M : 2014 : REDLINE | Standard Test Methods for Crosshole Seismic Testing |
| ASTM D 5220 : 2008 | Standard Test Method for Water Mass per Unit Volume of Soil and Rock In-Place by the Neutron Depth Probe Method |
| ASTM D 1452 : 2007 | Standard Practice for Soil Investigation and Sampling by Auger Borings |
| ASTM D 2922 : 2004 : EDT 1 | Standard Test Methods for Density of Soil and Soil-Aggregate in Place by Nuclear Methods (Shallow Depth) |
| ASTM D 5220 : 2014 | Standard Test Method for Water Mass per Unit Volume of Soil and Rock In-Place by the Neutron Depth Probe Method |
| ASTM D 2937 : 2017 : EDT 1 | Standard Test Method for Density of Soil in Place by the Drive-Cylinder Method |
| ASTM D 2216 : 1998 | Standard Test Method for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass |
| ASTM D 2216 : 1971 | Standard Method of Laboratory Determination Of Moisture Content Of Soil |
| ASTM D 5195 : 2014 | Standard Test Method for Density of Soil and Rock In-Place at Depths Below Surface by Nuclear Methods |
| ASTM D 3017 : 1996 : EDT 1 | Standard Test Method for Water Content of Soil and Rock in Place by Nuclear Methods (Shallow Depth) |
| ASTM D 2937 : 2004 | Standard Test Method for Density of Soil in Place by the Drive-Cylinder Method |
| ASTM D 5195 : 2014 : REDLINE | Standard Test Method for Density of Soil and Rock In-Place at Depths Below Surface by Nuclear Methods |
| ASTM D 1587 : 2000 | Standard Practice for Thin-Walled Tube Sampling of Soils for Geotechnical Purposes |
| ASTM D 5195 : 2014 : EDT 1 | Standard Test Method for Density of Soil and Rock In-Place at Depths Below Surface by Nuclear Methods |
| ASTM D 4564 : 2008 : EDT 1 | Standard Test Method for Density and Unit Weight of Soil in Place by the Sleeve Method (Withdrawn 2013) |
| ASTM D 3550 : 2001 | Standard Practice for Thick Wall, Ring-Lined, Split Barrel, Drive Sampling of Soils |
| ASTM D 1452 : 1980 : R2000 | Standard Practice for Soil Investigation and Sampling by Auger Borings |
| ASTM D 5195 : 2002 | Standard Test Method for Density of Soil and Rock In-Place at Depths Below the Surface by Nuclear Methods |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.