Customer Support: 131 242

i2i Intertek.com
  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Go to AMERICAS site
Dismiss alert
Please enter a keyword to search
Advanced search

ASTM D 76/D76M : 2011 : R2016

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Specification for Tensile Testing Machines for Textiles
Available format(s)

Hardcopy , PDF

Superseded date

20-08-2021

Language(s)

English

Published date

20-07-2016

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 07.01, 2016 Specifies the operating characteristics of three types of tensile testing machines used for the determination of the force-elongation properties of textile materials.

1.1This specification covers the operating characteristics of three types of tensile testing machines used for the determination of the force-elongation properties of textile materials. These types of tensile testing machines are:

1.1.1Constant-rate-of-extension, CRE.

1.1.2Constant-rate-of-traverse, CRT.

1.1.3Constant-rate-of-loading (force), CRL.

1.2Specifications for tensile testing machines to measure other tensile-related properties of textile materials not covered by this standard are given in the ASTM standards using those machines.

1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4The following safety hazards caveat pertains only to the test methods described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee
D 13
DevelopmentNote
Supersedes ASTM D 76. (12/2011)
DocumentType
Standard
Pages
7
ProductNote
Reconfirmed 2016
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM D 4632/D4632M : 2015 : REV A Standard Test Method for Grab Breaking Load and Elongation of Geotextiles
ASTM D 7004/D7004M : 2003 : R2021 Standard Test Method for Grab Tensile Properties of Reinforced Geomembranes
ASTM D 4885 : 2001 : R2018 Standard Test Method for Determining Performance Strength of Geomembranes by the Wide Strip Tensile Method
ASTM D 6818 : 2021 Standard Test Method for Tensile Properties of Rolled Erosion Control Products
ASTM D 5494 : 1993 : R2018 Standard Test Method for the Determination of Pyramid Puncture Resistance of Unprotected and Protected Geomembranes
ASTM D 5169 : 1998 : R2021 Standard Test Method for Shear Strength (Dynamic Method) of Hook and Loop Touch Fasteners
ASTM D 6637/D6637M : 2015 Standard Test Method for Determining Tensile Properties of Geogrids by the Single or Multi-Rib Tensile Method
ASTM E 4 : 2020 Standard Practices for Force Verification of Testing Machines<br>
ASTM D 6636 : 2001 : R2018 Standard Test Method for Determination of Ply Adhesion Strength of Reinforced Geomembranes
ASTM D 4833/D4833M : 2007 : R2020 Standard Test Method for Index Puncture Resistance of Geomembranes and Related Products
ASTM D 7747/D7747M : 2011 : R2018 Standard Test Method for Determining Integrity of Seams Produced Using Thermo-Fusion Methods for Reinforced Geomembranes by the Strip Tensile Method
ASTM D 4594/D4594M : 1996 : R2020 Standard Test Method for Effects of Temperature on Stability of Geotextiles
ASTM D 6241 : 2014 Standard Test Method for Static Puncture Strength of Geotextiles and Geotextile-Related Products Using a 50-mm Probe
ASTM D 6768/D6768M : 2020 Standard Test Method for Tensile Strength of Geosynthetic Clay Liners
ASTM D 4884/D4884M : 2014 : REV A Standard Test Method for Strength of Sewn or Bonded Seams of Geotextiles
ASTM D 7005/D7005M : 2016 Standard Test Method for Determining the Bond Strength (Ply Adhesion) of Geocomposites
ASTM D 7842/D7842M : 2012 : R2021 Standard Test Method for Holding Strength of Tack and Prong Fastener Attached Buttons
ASTM D 4846 : 1996 : R2021 Standard Test Method for Resistance to Unsnapping of Snap Fasteners
ASTM D 7003/D7003M : 2003 : R2021 Standard Test Method for Strip Tensile Properties of Reinforced Geomembranes
ASTM D 8199 : 2020 Standard Test Method for Determining the Specific Strength of Hydraulically Applied Fiber Matrix Products for Erosion Control
ASTM D 4533/D4533M : 2015 Standard Test Method for Trapezoid Tearing Strength of Geotextiles
ASTM D 6496/D6496M : 2020 Standard Test Method for Determining Average Bonding Peel Strength Between Top and Bottom Layers of Needle-Punched Geosynthetic Clay Liners
ASTM E 2098/E2098M : 2013 : R2018 Standard Test Method for Determining Tensile Breaking Strength of Glass Fiber Reinforcing Mesh for Use in Class PB Exterior Insulation and Finish Systems (EIFS), after Exposure to a Sodium Hydroxide Solution
ASTM D 7749 : 2011 : R2018 Standard Test Method for Determining Integrity of Seams Produced Using Thermo-Fusion Methods for Reinforced Geomembranes by the Grab Method
ASTM D 7556 : 2010 : R2019 Standard Test Methods for Determining Small-Strain Tensile Properties of Geogrids and Geotextiles by In-Air Cyclic Tension Tests
ASTM D 8172 : 2018 Standard Test Method for Shear and Peel Strength of Solvent-Welded Seams with Nonreinforced Geomembranes
ASTM D 7179 : 2018 Standard Test Method for Determining Geonet Breaking Force

ASTM D 4849 : 2013 : EDT 3 Standard Terminology Related to Yarns and Fibers
ASTM D 2256 : 2002 Standard Test Method for Tensile Properties of Yarns by the Single-Strand Method
ASTM D 4849 : 2020 Standard Terminology Related to Yarns and Fibers
ASTM D 4849 : 2013 : EDT 2 Standard Terminology Related to Yarns and Fibers
ASTM D 4849 : 2002 : REV A Standard Terminology Relating to Yarns and Fibers
ASTM D 4849 : 2013 : R2018 Standard Terminology Related to Yarns and Fibers
ASTM D 4849 : 2002 : REV B Standard Terminology Relating to Yarns and Fibers
ASTM D 4849 : 2002 : REV B : R2007 : EDT 2 Standard Terminology Related to Yarns and Fibers
ASTM D 4849 : 2002 : REV B : EDT 1 Standard Terminology Relating to Yarns and Fibers
ASTM D 4849 : 2002 : REV B : R2007 : EDT 1 Standard Terminology Related to Yarns and Fibers
ASTM D 2256 : 1997 Standard Test Method for Tensile Properties of Yarns by the Single-Strand Method
ASTM D 4849 : 2021 Standard Terminology Related to Yarns and Fibers
ASTM D 4849 : 2002 : REV B : R2007 Standard Terminology Relating to Yarns and Fibers
ASTM D 123 : 2001 Standard Terminology Relating to Textiles
ASTM D 4849 : 2013 Standard Terminology Related to Yarns and Fibers
ASTM D 4849 : 2002 : REV B : R2007 : EDT 3 Standard Terminology Related to Yarns and Fibers
ASTM D 4849 : 2013 : EDT 1 Standard Terminology Related to Yarns and Fibers
ASTM D 2256 : 2002 : R2008 Standard Test Method for Tensile Properties of Yarns by the Single-Strand Method

View more information
$122.77
Including GST where applicable
AUD
CAD
CHF
CNY
DKK
EUR
GBP
HKD
IDR
INR
JPY
KRW
MXN
NOK
NZD
SEK
SGD
USD
ZAR
Hardcopy - English
PDF - English
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

or

Get in touch with us

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more