Customer Support: 131 242

i2i Intertek.com
  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Go to AMERICAS site
Dismiss alert
Please enter a keyword to search
Advanced search

ASTM E 154/E154M : 2008 : REV A : R2013 : EDT 1

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Test Methods for Water Vapor Retarders Used in Contact with Earth Under Concrete Slabs, on Walls, or as Ground Cover
Available format(s)

Hardcopy , PDF

Superseded date

03-07-2019

Language(s)

English

Published date

01-04-2013

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 04.11, 2015 Defines the determination of the properties of flexible membranes to be used as vapor retarders in contact with earth under concrete slabs, against walls, or as ground cover in crawl spaces.

1.1These test methods2 cover the determination of the properties of flexible membranes to be used as vapor retarders in contact with earth under concrete slabs, against walls, or as ground cover in crawl spaces. The test methods are applicable primarily to plastic films and other flexible sheets. The materials are not intended to be subjected to sustained hydrostatic pressure. The procedures simulate conditions to which vapor retarders may be subjected prior to and during installation, and in service.

1.2The test methods included are:

Section

Water-Vapor Transmission of Material as Received

7

Water-Vapor Transmission after Wetting and Drying and after Long-
 Time Soaking

8

Tensile Strength

9

Resistance to Puncture

10

Resistance to Plastic Flow and Elevated Temperature

11

Effect of Low Temperatures on Flexibility

12

Resistance to Deterioration from Organisms and Substances in Con-
 tacting Soil

13

Resistance to Deterioration from Petroleum Vehicles for Soil Poisons

14

Resistance to Deterioration from Exposure to Ultraviolet Light

15

Resistance to Flame Spread

16

Report

17


1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee
E 06
DevelopmentNote
Supersedes ASTM E 154. (05/2013)
DocumentType
Test Method
Pages
7
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM D 6455 : 2011 Standard Guide for the Selection of Test Methods for Prefabricated Bituminous Geomembranes (PBGM)
ASTM E 1993/E1993M : 1998 : R2013 : EDT 1 Standard Specification for Bituminous Water Vapor Retarders Used in Contact with Soil or Granular Fill Under Concrete Slabs
ASTM D 6455 : 2011 : R2018 Standard Guide for the Selection of Test Methods for Prefabricated Bituminous Geomembranes (PBGMs)
ASTM D 6506/D6506M : 2001 : R2018 : EDT 1 Standard Specification for Asphalt Based Protection Board for Below-Grade Waterproofing
ASTM E 1745 : 2017 : REDLINE Standard Specification for Plastic Water Vapor Retarders Used in Contact with Soil or Granular Fill under Concrete Slabs

ASTM E 631 : 2015 : REDLINE Standard Terminology of Building Constructions
ASTM D 828 : 2016 Standard Test Method for Tensile Properties of Paper and Paperboard Using Constant-Rate-of-Elongation Apparatus
ASTM D 4397 : 2016 : REDLINE Standard Specification for Polyethylene Sheeting for Construction, Industrial, and Agricultural Applications
ASTM D 2565 : 2016 : REDLINE Standard Practice for Xenon-Arc Exposure of Plastics Intended for Outdoor Applications
ASTM F 1249 : 2013 : REDLINE Standard Test Method for Water Vapor Transmission Rate Through Plastic Film and Sheeting Using a Modulated Infrared Sensor
ASTM C 168 : 2017-06 TERMINOLOGY RELATING TO THERMAL INSULATION
ASTM D 1985 : 2013 Standard Practice for Preparing Concrete Blocks for Testing Sealants, for Joints and Cracks

View more information
$122.77
Including GST where applicable
AUD
CAD
CHF
CNY
DKK
EUR
GBP
HKD
IDR
INR
JPY
KRW
MXN
NOK
NZD
SEK
SGD
USD
ZAR
Hardcopy - English
PDF - English
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

or

Get in touch with us

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more