Customer Support: 131 242

  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ASTM E 2913/E2913M : 2019

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Practice for Hotplate Digestion of Lead from Composited Wipe Samples
Available format(s)

Hardcopy , PDF

Superseded date

05-11-2021

Language(s)

English

Published date

16-05-2019

This practice is similar to PracticeE1644and covers the hot, nitric acid digestion of lead (Pb) from a composited sample of up to four individual wipe samples of settled dust collected from equally-sized areas in the same space.

1.1This practice is similar to Practice E1644 and covers the hot, nitric acid digestion of lead (Pb) from a composited sample of up to four individual wipe samples of settled dust collected from equally-sized areas in the same space.

1.2This practice contains notes which are explanatory and not part of mandatory requirements of the practice.

1.3This practice should be used by analysts experienced in digestion techniques such as hot blocks. Like all procedures used in an analytical laboratory, this practice needs to be validated for use and shown to produce acceptable results before being applied to client samples.

1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee
D 22
DocumentType
Standard Practice
Pages
4
ProductNote
THIS STANDARD ALSO REFERS TO 40 CFR Part 745
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM E 3193 : 2021 Standard Test Method for Measurement of Lead (Pb) in Dust by Wipe, Paint, and Soil by Flame Atomic Absorption Spectrophotometry (FAAS)

ASTM E 1792 : 2003 Standard Specification for Wipe Sampling Materials for Lead in Surface Dust
ASTM E 1792 : 2003 : R2011 Standard Specification for Wipe Sampling Materials for Lead in Surface Dust
ASTM E 1792 : 2001 Standard Specification for Wipe Sampling Materials for Lead in Surface Dust
ASTM E 1792 : 2003 : R2016 Standard Specification for Wipe Sampling Materials for Lead in Surface Dust
ASTM D 1129 : 2003 Standard Terminology Relating to Water
ASTM D 1129 : 2013 Standard Terminology Relating to Water
ASTM D 1129 : 2013 : R2020 Standard Terminology Relating to Water
ASTM D 6966 : 2018 Standard Practice for Collection of Settled Dust Samples Using Wipe Sampling Methods for Subsequent Determination of Metals
ASTM D 1193 : 1977 : R1983 : EDT 1 Standard Specification for Reagent Water
ASTM E 1644 : 2004 : R2012 : EDT 1 Standard Practice for Hot Plate Digestion of Dust Wipe Samples for the Determination of Lead
ASTM E 1613 : 2012 Standard Test Method for Determination of Lead by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES), Flame Atomic Absorption Spectrometry (FAAS), or Graphite Furnace Atomic Absorption Spectrometry (GFAAS) Techniques (Withdrawn 2021)
ASTM E 1644 : 2017 Standard Practice for Hot Plate Digestion of Dust Wipe Samples for the Determination of Lead
ASTM D 1129 : 2006 Standard Terminology Relating to Water
ASTM E 1605 : 2001 : REV B Standard Terminology Relating to Lead in Buildings
ASTM E 1728 : 1999 Standard Practice for Field Collection of Settled Dust Samples Using Wipe Sampling Methods for Lead Determination by Atomic Spectrometry Techniques
ASTM D 6966 : 2008 Standard Practice for Collection of Settled Dust Samples Using Wipe Sampling Methods for Subsequent Determination of Metals
ASTM E 2239 : 2012 Standard Practice for Record Keeping and Record Preservation for Lead Hazard Activities
ASTM D 1129 : 1999 : REV A Standard Terminology Relating to Water
ASTM D 1129 : 2006 : REV A Standard Terminology Relating to Water
ASTM D 1193 : 2006 : R2011 Standard Specification for Reagent Water
ASTM E 2239 : 2012 : R2016 Standard Practice for Record Keeping and Record Preservation for Lead Hazard Activities
ASTM E 1605 : 2000 Standard Terminology Relating to Lead in Buildings
ASTM E 1728 : 2016 Standard Practice for Collection of Settled Dust Samples Using Wipe Sampling Methods for Subsequent Lead Determination
ASTM E 1605 : 2018 Standard Terminology Relating to Lead in Buildings
ASTM D 1129 : 2003 : REV A Standard Terminology Relating to Water
ASTM D 1129 : 2002 Standard Terminology Relating to Water
ASTM E 1605 : 2018 : REV A Standard Terminology Relating to Lead in Buildings
ASTM E 1613 : 1999 Standard Test Method for Determination of Lead by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES), Flame Atomic Absorption Spectrometry (FAAS), or Graphite Furnace Atomic Absorption Spectrometry (GFAAS) Techniques
ASTM E 1605 : 2001 : REV A Standard Terminology Relating to Lead in Buildings
ASTM E 1728 : 2002 Standard Practice for Collection of Settled Dust Samples Using Wipe Sampling Methods for Subsequent Lead Determination
ASTM E 1792 : 2002 Standard Specification for Wipe Sampling Materials for Lead in Surface Dust
ASTM D 1193 : 1991 Standard Specification for Reagent Water
ASTM E 2051 : 2001 Standard Practice for the Determination of Lead in Paint, Settled Dust, Soil and Air Particulate by Field-Portable Electroanalysis (Withdrawn 2010)
ASTM E 1605 : 2003 : EDT 1 Standard Terminology Relating to Lead in Buildings
ASTM E 1605 : 2019 Standard Terminology Relating to Lead in Buildings
ASTM E 1728 : 2010 Standard Practice for Collection of Settled Dust Samples Using Wipe Sampling Methods for Subsequent Lead Determination
ASTM D 1129 : 2004 Standard Terminology Relating to Water
ASTM D 6966 : 2003 Standard Practice for Collection of Settled Dust Samples Using Wipe Sampling Methods for Subsequent Determination of Metals
ASTM E 1605 : 2003 Standard Terminology Relating to Lead in Buildings
ASTM E 1613 : 2004 Standard Test Method for Determination of Lead by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES), Flame Atomic Absorption Spectrometry (FAAS), or Graphite Furnace Atomic Absorption Spectrometry (GFAAS) Techniques
ASTM D 1129 : 2002 : REV A Standard Terminology Relating to Water
ASTM E 1605 : 2018 : REV B Standard Terminology Relating to Lead in Buildings
ASTM E 2239 : 2003 Standard Practice for Record Keeping and Record Preservation for Lead Hazard Activities
ASTM E 1792 : 2001 : EDT 1 Standard Specification for Wipe Sampling Materials for Lead in Surface Dust
ASTM E 1605 : 2004 Standard Terminology Relating to Lead in Buildings
ASTM E 1644 : 2004 Standard Practice for Hot Plate Digestion of Dust Wipe Samples for the Determination of Lead
ASTM D 1193 : 1970 Standard Specification For Reagent Water
ASTM D 1193 : 2006 Standard Specification for Reagent Water
ASTM E 2239 : 2004 Standard Practice for Record Keeping and Record Preservation for Lead Hazard Activities
ASTM E 1644 : 1998 Standard Practice for Hot Plate Digestion of Dust Wipe Samples for the Determination of Lead
ASTM D 1193 : 1999 Standard Specification for Reagent Water
ASTM D 1129 : 2010 Standard Terminology Relating to Water
ASTM E 1792 : 1996 : REV A Standard Specification for Wipe Sampling Materials for Lead in Surface Dust
ASTM E 1605 : 2001 Standard Terminology Relating to Lead in Buildings
ASTM D 1129 : 2006 : REV A : EDT 1 Standard Terminology Relating to Water
ASTM D 1129 : 2001 Standard Terminology Relating to Water
ASTM D 1129 : 2004 : EDT 1 Standard Terminology Relating to Water
ASTM E 1644 : 2004 : R2016 : EDT 1 Standard Practice for Hot Plate Digestion of Dust Wipe Samples for the Determination of Lead
ASTM D 1193 : 2006 : R2018 Standard Specification for Reagent Water
ASTM E 1605 : 2004 : R2012 Standard Terminology Relating to Lead in Buildings
ASTM D 6966 : 2013 Standard Practice for Collection of Settled Dust Samples Using Wipe Sampling Methods for Subsequent Determination of Metals
ASTM E 1605 : 2002 Standard Terminology Relating to Lead in Buildings
ASTM E 1728 : 2003 Standard Practice for Collection of Settled Dust Samples Using Wipe Sampling Methods for Subsequent Lead Determination
ASTM E 2239 : 2002 Standard Practice for Record Keeping and Record Preservation for Lead Hazard Activities

View more information
$108.03
Including GST where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more