Standard Specification for Wrought Nitrogen Strengthened 22 Chromium–13 Nickel–5 Manganese–2.5 Molybdenum Stainless Steel Alloy Bar and Wire for Surgical Implants (UNS S20910)

Available format(s)

PDF

Language(s)

English

Published date

01-02-2018

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 13.01, 2018 Defines the chemical, mechanical, and metallurgical requirements for wrought nitrogen strengthened 22 chromium -13 nickel -5 manganese -2.5 molybdenum stainless steel alloy bar and wire for surgical implants.

1.1This specification covers the chemical, mechanical, and metallurgical requirements for wrought nitrogen strengthened 22 chromium – 13 nickel – 5 manganese – 2.5 molybdenum stainless steel alloy bar and wire for surgical implants.

1.2The SI units in this standard are the primary units. The values stated in either primary SI units or secondary inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of each other. Combining values form the two systems may result in non-conformance with the standard.

1.3This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 04
DevelopmentNote	Supersedes and redesignates ASTM F 1314/F1314M. (12/2013)
DocumentType	Redline
Pages	7
PublisherName	American Society for Testing and Materials
Status	Current

SAE AMS 2248 : 2016	CHEMICAL CHECK ANALYSIS LIMITS, CORROSION AND HEAT-RESISTANT STEELS AND ALLOYS, MARAGING AND OTHER HIGHLY-ALLOYED STEELS, AND IRON ALLOYS
ASTM A 262 : 2015 : REDLINE	Standard Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels
SAE AMS 2630 : 2010	INSPECTION, ULTRASONIC, PRODUCT OVER 0.5 INCH (12.7 MM) THICK
SAE AMS 2632 : 1995	INSPECTION, ULTRASONIC, OF THIN MATERIALS 0.5 INCH (12.77 MM) AND UNDER IN CROSS-SECTIONAL THICKNESS
ISO 6892:1998	Metallic materials Tensile testing at ambient temperature
ASTM E 10 : 2017-05	TEST METHOD FOR BRINELL HARDNESS OF METALLIC MATERIALS
IEEE/ASTM SI_10-2010	American National Standard for Metric Practice
ISO 9001:2015	Quality management systems — Requirements
ASTM A 555/A555M : 2016 : REDLINE	Standard Specification for General Requirements for Stainless Steel Wire and Wire Rods
ASTM E 354 : 2014 : REDLINE	Standard Test Methods for Chemical Analysis of High-Temperature, Electrical, Magnetic, and Other Similar Iron, Nickel, and Cobalt Alloys
ASTM E 8/E8M : 2016-09	TEST METHODS FOR TENSION TESTING OF METALLIC MATERIALS