ASTM F 2018 : 2000

Name: ASTM F 2018 : 2000
Brand: ASTM
Price: 122.77 AUD

Superseded

Standard Test Method for Time-to-Failure of Plastics Using Plane Strain Tensile Specimens

Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

10-05-2000

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 08.04, 2018 Defines the requirements to determine the time-to-failure of thermoplastic resins for piping applications by uniaxial loading of a grooved tensile test specimen.

1.1 This test method covers the requirements to determine the time-to-failure of thermoplastic resins for piping applications by uniaxial loading of a grooved tensile test specimen. This grooved tensile specimen achieves a multi-axial stress condition, which mimics the stress condition found in pressurized solid-wall plastic pipe. The ratio of the stress in the axial direction to the transverse direction approximates that for a pressurized solid-wall pipe specimen.

1.2 It is intended that the data generated on these specimens be analyzed according to the methodology set forth in Test Method D 2837 to generate a long-term strength design value for the material.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee	F 17
DocumentType	Test Method
Pages	5
ProductNote	Reconfirmed 2000
PublisherName	American Society for Testing and Materials
Status	Superseded

PPI TR 4 : 2017	HDB/HDS/SDB/PDB/MRS LISTED MATERIALS - PPI LISTING OF HYDROSTATIC DESIGN BASIS (HDB), HYDROSTATIC DESIGN STRESS (HDS), STRENGTH DESIGN BASIS (SDB), PRESSURE DESIGN BASIS (PDB) AND MINIMUM REQUIRED STRENGTH (MRS) RATINGS FOR THERMOPLASTIC PIPING MATERIALS OR PIPE
ASTM D 4703 : 2016 : REDLINE	Standard Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets
ASTM D 2990 : 2017 : REDLINE	Standard Test Methods for Tensile, Compressive, and Flexural Creep and Creep-Rupture of Plastics