Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

22-12-2020

Publisher

American Society for Testing and Materials

1.1This test method covers laboratory procedures for determining the resistance of metallic materials to scratching abrasion by means of the wet sand/rubber wheel test. It is the intent of this procedure to provide data that will reproducibly rank materials in their resistance to scratching abrasion under a specified set of conditions.

1.2Abrasion test results are reported as volume loss in cubic millimetres. Materials of higher abrasion resistance will have a lower volume loss.

1.3The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	G 02
DocumentType	Test Method
Pages	10
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM G 105 : 2016

ASTM E 11 : 2020	Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves
ASTM E 177 : 1990 : REV A : R1996	Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM G 40 : 2021	Standard Terminology Relating to Wear and Erosion
ASTM E 122 : 2017 : R2022	Standard Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process
ASTM E 122 : 2017	Standard Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process
ASTM E 11 : 2022	Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves
ASTM G 40 : 2021 : REV A	Standard Terminology Relating to Wear and Erosion
ASTM D 2240 : 2015 : R2021	Standard Test Method for Rubber Property—Durometer Hardness
ASTM G 40 : 2022	Standard Terminology Relating to Wear and Erosion
ASTM G 40 : 2022 : REV A	Standard Terminology Relating to Wear and Erosion
ASTM D 2240 : 2015 : EDT 1	Standard Test Method for Rubber Property—Durometer Hardness
ASTM G 40 : 2017	Standard Terminology Relating to Wear and Erosion