1 - ATS 5200.055-2008 TECHNICAL SPECIFICATIONS FOR PLUMBING AND DRAINAGE PRODUCTS - PLASTICS FITTINGS-CONNECTORS WITH...
4 - PREFACE
5 - CONTENTS
6 - 1 SCOPE
6 - 2 APPLICATION
6 - 3 REFERENCED DOCUMENTS
7 - 4 DEFINITIONS
7 - 4.1 Expander joint
7 - 4.2 Swivel joint
7 - 5 MATERIALS
7 - 5.1 Plastics materials
7 - 5.1.1 General
7 - 5.1.2 Unplasticized polyvinyl chloride (PVC-U)
7 - 5.1.3 Acrylonitrile butadiene styrene (ABS)
7 - 5.1.4 Acrylonitrile styrene acrylate (ASA)
8 - 5.1.5 Polypropylene (PP)
8 - 5.1.6 Polyethylene (PE)
8 - 5.2 Elastomeric jointing seals
8 - 5.3 Solvent cement
8 - 6 MARKING
8 - 7 PACKAGING
8 - 8 DESIGN
8 - 8.1 End connectors
8 - 8.1.1 Solvent-welded joints
9 - 8.1.2 Elastomeric seal (rubber ring) joints
9 - 8.2 Dimensions
9 - 8.2.1 General
9 - 8.2.2 Waterway/Clear bore
9 - 8.3 Freedom from defects
9 - 8.4 Expander and swivel joints
9 - 8.4.1 Protection barrier
9 - 8.4.2 End stop
10 - 9 PERFORMANCE REQUIREMENTS AND TEST METHODS
10 - 9.1 Solvent-welded joints (ABS/PVC or ASA/PVC)
10 - 9.1.1 Joint strength
10 - 9.1.2 Shear strength
10 - 9.2 Elastomeric joints-Contact width and pressure
10 - 9.3 Fitting-Hydrostatic pressure test
10 - 9.4 Fitting-Liquid infiltration test
10 - 9.5 Fitting-High temperature stress-relief test (Injection-moulded fittings-PVC/ABS/ASA)
10 - 10 ‘VOID’
10 - 11 PRODUCT DOCUMENTATION
10 - 11.1 Product data
10 - 11.2 Installation instructions
12 - APPENDIX A - MEANS FOR DEMONSTRATING COMPLIANCE WITH THIS AUSTRALIAN TECHNICAL SPECIFICATION
12 - A1 SCOPE
12 - A2 RELEVANCE
12 - A3 PRODUCT CERTIFICATION
12 - A4 DEFINITIONS
12 - A4.1 Sample
12 - A4.2 Sampling plan
12 - A4.3 Type test batch
12 - A4.4 Type testing
12 - A5 TESTING
12 - A5.1 Type testing
13 - A5.2 Batch release testing
13 - A5.3 Retesting
15 - APPENDIX B - JOINT SHEAR STRENGTH TEST
15 - B1 SCOPE
15 - B2 PRINCIPLE
15 - B3 APPARATUS
15 - B4 TEST SPECIMEN PREPARATION
15 - B5 PREPARATION OF TEST ASSEMBLIES
17 - B6 PROCEDURE
17 - B7 CALCULATIONS
17 - B8 TEST REPORT