Name: BS 5412&5413-5(1976) : AMD 4591
Brand: BSI

BS 5412&5413-5(1976) : AMD 4591

Superseded

SPECIFICATION FOR THE PERFORMANCE OF DRAW-OFF TAPS WITH METAL BODIES FOR WATER SERVICES - PHYSIO-CHEMICAL CHARACTERISTICS MATERIALS COATINGS

Superseded date

15-01-1996

Published date

23-11-2012

Publisher

British Standards Institution

Foreword
Cooperating organizations
Specification
Section one. General
1 Scope
2 References
3 Definitions
4 Requirements for compliance with BS 5412 and BS 5413
5 Nominal size
6 Marking
7 Identification of taps
Section two. Physio-chemical characteristics:
              materials, coatings
8 General
9 Materials
10 Application of materials
11 Coatings
12 Workmanship
Appendices
A Low temperature test for 'O'-rings and other
    elastomeric type seals
B Properties of materials and test requirements for
    'O'-rings and other elastomeric type seals
C Adhesion to and corrosion of metals and plastics
    material by 'O'-rings and other elastomeric type
    seals. Test methods
D Properties of lubricating oils for materials tests
    for 'O'-rings and other elastomeric type seals
E Method for the determination of surface conditions
    of 'O'-ring and other elastomeric type seal
    materials on bending after ageing in air
F Method for the determination of tensile elongation
    at break of plastic materials
Figures
1 Adhesion and corrosion test apparatus
2 Test specimen

Defines the physio-chemical characteristics and tests for half and three-quarter nominal size draw-off taps. Relates to following types of tap: pillar and bib taps, combination tap assemblies, single hole combination tap assemblies, and three hole combination tap assemblies.

Committee	SEB/2
DevelopmentNote	ALSO NUMBERED AS BS 5413 PART 5 1976
DocumentType	Standard
PublisherName	British Standards Institution
Status	Superseded
SupersededBy	BS 5412:1996

BS 1206:1974	Specification for fireclay sinks: dimensions and workmanship
BS 6282-4:1982	Devices with moving parts for the prevention of contamination of water by backflow Specification for combined check and anti-vacuum valves of nominal size up to and including DN 42
BS 6340-4:1984	Shower units Specification for shower heads and related equipment
BS 6281-3:1982	Devices without moving parts for the prevention of contamination of water by backflow Specification for pipe interrupters of nominal size up to and including DN 42
BS 6282-1:1982	Devices with moving parts for the prevention of contamination of water by backflow Specification for check valves of nominal size up to and including DN 54
BS 2879:1980	Specification for draining taps (screw-down pattern)
BS 6282-3:1982	Devices with moving parts for the prevention of contamination of water by backflow Specification for in-line anti-vacuum valves of nominal size up to and including DN 42
BS 6340-2:1983	Shower units Specification for the installation of shower units
BS 5779:1979	Specification for spray mixing taps
BS 6282-2:1982	Devices with moving parts for the prevention of contamination of water by backflow Specification for terminal anti-vacuum valves of nominal size up to and including DN 54

BS 2871-1:1971	Specification for copper and copper alloys. Tubes Copper tubes for water, gas and sanitation
BS 970-4:1970	Specification for wrought steels for mechanical and allied engineering purposes Valve steels
BS 903-A26:1969	Physical testing of rubber Determination of hardness
BS 1010-2:1973	Specification for draw-off taps and stopvalves for water services (screw-down pattern) Draw-off taps and above-ground stopvalves