We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • BS 8621(2007) : 2007

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    THIEF RESISTANT LOCK ASSEMBLY - KEYLESS EGRESS

    Available format(s):  Hardcopy, PDF

    Superseded date:  30-06-2017

    Language(s):  English

    Published date:  01-01-2007

    Publisher:  British Standards Institution

    Add to Watchlist

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Locks
    5 Cylinder for a lock
    6 General vulnerability of lock assembly
    7 Differs
    8 Master keyed locks
    9 Marking
    10 Information to be supplied by the manufacturer
    Annex A (normative) - General vulnerability assessment
    Annex B (normative) - Assessment panel
    Bibliography

    Abstract - (Show below) - (Hide below)

    Defines performance requirements and test methods for a thief resistant mechanically operated single-point lock assembly including locking plates, fixing screws, fitting instructions, cylinders and protective furniture where appropriate.

    General Product Information - (Show below) - (Hide below)

    Committee B/538/4
    Development Note Supersedes BS 8621(2004) and 07/30167588 DC. (08/2007) Supersedes 08/30189024 DC. (09/2009) 2007 Edition Re-Issued in May 2012 & incorporates AMD 2 2012. Supersedes 11/30256238 DC. (06/2012)
    Document Type Standard
    Publisher British Standards Institution
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    BS 10621(2017) : 2017 LOCK ASSEMBLIES IN WHICH THE OPERATING MODE CAN BE SWITCHED BETWEEN THE NORMAL BS 8621 OPERATING MODE AND A SECURE MODE IN WHICH NO EGRESS IS POSSIBLE
    BS 3621(2017) : 2017 LOCK ASSEMBLIES OPERATED BY KEY FROM BOTH THE INSIDE AND OUTSIDE OF THE DOOR
    16/30338190 DC : 0 BS 3621 - LOCK ASSEMBLIES OPERATED BY KEY FROM BOTH THE INSIDE AND OUTSIDE OF THE DOOR
    BS PAS 8621(2011) : 2011 MULTIPOINT LOCKING ASSEMBLIES - KEYLESS EGRESS - PERFORMANCE REQUIREMENTS AND TEST METHODS
    08/30182649 DC : DRAFT MAY 2008 BS 8300 - DESIGN OF BUILDINGS AND THEIR APPROACHES TO MEET THE NEEDS OF DISABLED PEOPLE - CODE OF PRACTICE
    BS 10621(2007) : 2007 THIEF RESISTANT DUAL-MODE LOCK ASSEMBLY
    BS 8300(2009) : 2009 DESIGN OF BUILDINGS AND THEIR APPROACHES TO MEET THE NEEDS OF DISABLED PEOPLE - CODE OF PRACTICE
    BS 10621:2017 LOCK ASSEMBLIES IN WHICH THE OPERATING MODE CAN BE SWITCHED BETWEEN THE NORMAL BS 8621 OPERATING MODE AND A SECURE MODE IN WHICH NO EGRESS IS POSSIBLE
    BS 3621:2017 LOCK ASSEMBLIES OPERATED BY KEY FROM BOTH THE INSIDE AND OUTSIDE OF THE DOOR

    Standards Referencing This Book - (Show below) - (Hide below)

    BS EN 1303:2015 Building hardware. Cylinders for locks. Requirements and test methods
    BS EN 12209:2016 BUILDING HARDWARE - MECHANICALLY OPERATED LOCKS AND LOCKING PLATES - REQUIREMENTS AND TEST METHODS
    89/106/EEC : 1988 COUNCIL DIRECTIVE OF 21 DECEMBER 1988 ON THE APPROXIMATION OF LAWS, REGULATIONS AND ADMINISTRATIVE PROVISIONS OF THE MEMBER STATES RELATING TO CONSTRUCTION PRODUCTS
    BS EN 1125 : 2008 BUILDING HARDWARE - PANIC EXIT DEVICES OPERATED BY A HORIZONTAL BAR, FOR USE ON ESCAPE ROUTES - REQUIREMENTS AND TEST METHODS
    BS PAS 24(2012) : 2012 ENHANCED SECURITY PERFORMANCE REQUIREMENTS FOR DOORSETS AND WINDOWS IN THE UK - EXTERNAL DOORSETS AND WINDOWS INTENDED TO OFFER A LEVEL OF SECURITY SUITABLE FOR DWELLINGS AND OTHER BUILDINGS EXPOSED TO COMPARABLE RISK
    BS EN 45011 : 1998 GENERAL REQUIREMENTS FOR BODIES OPERATING PRODUCT CERTIFICATION SYSTEMS
    BS 7398(1991) : 1991 SPECIFICATION FOR HAND HACKSAW FRAMES
    BS EN 179 : 2008 BUILDING HARDWARE - EMERGENCY EXIT DEVICES OPERATED BY A LEVER HANDLE OR PUSH PAD, FOR USE ON ESCAPE ROUTES - REQUIREMENTS AND TEST METHODS
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective