BS EN 22768-2:1993
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
22-02-2021
English
15-07-1993
Cooperating organizations
National foreword
Introduction
Specification
1 Scope
2 General
3 Normative references
4 Definitions
5 General geometrical tolerances
6 Indications on drawings
7 Rejection
Annexes
A (informative) Concepts behind general tolerancing
of geometrical characteristics
B (informative) Further information
ZA (normative) Normative references to international
publications with their relevant European
publications
Tables
1 General tolerances on straightness and flatness
2 General tolerances on perpendicularity
3 General tolerances on symmetry
4 General tolerances on circular run-out
Figures
B.1 Principle of independency: maximum permissible
deviations on the same feature
B.2 Examples of general tolerances on circularity
B.3 Parallelism deviation equal to the numerical value
of the size tolerance
B.4 Parallelism deviation equal to the numerical value
of the straightness tolerance
B.5 Examples of general tolerances on symmetry
B.6 Example of general tolerances on a drawing
National annex
NA (informative) Committees responsible
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.