BS EN 60922:1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Auxiliaries for lamps. Ballasts for discharge lamps (excluding tubular fluorescent lamps). General and safety requirements
Hardcopy , PDF
15-05-2001
English
15-09-1997
INTRODUCTION
SECTION 1: GENERAL REQUIREMENTS
1 General
1.1 Scope and object
1.2 Normative references
2 Definitions
3 General requirements
4 General notes on tests
5 Classification
6 Marking
6.1 Mandatory markings
6.2 Information to be provided, if applicable
6.3 Other information
6.4 Marking shall be durable and legible
SECTION 2: SAFETY REQUIREMENTS
7 Protection against accidental contact with live parts
8 Terminals
9 Provisions for earthing
10 Moisture resistance and insulation
11 High-voltage impulse test
12 Thermal endurance of windings
13 Ballast heating
14 Screws, current-carrying parts and connections
15 Creepage distances and clearances
16 Resistance to heat, fire and tracking
17 Resistance to corrosion
Figures
Annexes
A Thermal endurance test for windings
b The use of constants S other than 4500 in Tw tests
C Draught-proof enclosure
D Method of selection of varistors
E Explanation to ballast temperatures
F Particular requirements for thermally protected ballasts
ZA (normative) Normative references to international
publications with their corresponding European
publications
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.