Radio-frequency connectors. RF coaxial connectors with inner diameter of outer conductor 3 mm (0,12 in) with snap-on coupling. Characteristic impedance 50 ohms (Type SMB)

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

15-01-1997

Publisher

British Standards Institution

Committees responsible
National foreword
Specification
1 Scope
2 IEC type designation
3 Ratings
4 Preferred climatic categories
5 Dimensions - General purpose connectors - Grade 2
6 Gauges and standard test connectors - Grade 0
7 Survey of patterns
8 Outline dimensions
9 Schedule for type tests
10 Quality assessment procedures
Figures
1A Connector with pin-centre contact
1B Details of pin contact
1C/D Alternative indication of details of groove
2A Connector with socket-centre contact
2B Details of socket contact
3 Gauge pins for centre contact for socket connector
4 Gauges for outer contact of plug
4A/B Alternative indication of details of groove
5A Dimensions of connector
5B Dimensions of centre contact
6A Dimensions of connector
6B Dimensions of centre contact
7 Free connector (straight) with socket contact
8 Fixed connector (single hole panel mounting with
     entry for r.f. cable) with pin contact
9 Free connector (right angle) with socket contact
10 Fixed connector (single-hole rear panel mounting
     with solder bucket) with pin contact
11 Fixed connector (four-hole panel mounting with
     solder bucket) with pin contact
12 Fixed connector, printed circuit mounting (straight)
     with pin contact
13 Fixed connector (right angle, single hole panel
     mounting with solder bucket) with pin contact
14 Fixed connector, printed circuit mounting
     (right angle) with pin contact
15 Fixed adaptor (single-hole panel mounting) with
     pin-pin contacts

Radio-frequency (RF) coaxial connectors used with RF cables. These connector patterns are for low power, using a snap-on coupling mechanism and are commonly known as Type SMB.

Committee	EPL/46
DevelopmentNote	Also numbered as IEC 60169-10 (08/2005) Reviewed and confirmed by BSI, October 2005. (09/2005)
DocumentType	Standard
Pages	48
PublisherName	British Standards Institution
Status	Current

BS 2011-2.1M:1984	Environmental testing. Tests Test M. Low air pressure
BS EN 61169-1:2013	Radio-frequency connectors Generic specification. General requirements and measuring methods
BS 2011-2.1N:1985	Environmental testing. Tests Test N. Change of temperature
BS 2011-2.1Ca:1977	Environmental testing. Tests Test Ca. Damp heat, steady state
BS EN 60068-2-1:2007	Environmental testing Tests. Test A. Cold
BS 3041-1:1977	Radio-frequency connectors Specification for general requirements and measuring methods
BS 2011-2.1Ka:1982	Environmental testing. Tests Test Ka.Salt mist
BS EN 60068-2-2:2007	Environmental testing Tests. Test B. Dry heat
BS 2011-2.1T:1981	Environmental testing. Tests Test T. Soldering