Information Technology - 8 mm Wide Magnetic Tape Cartridge for Information Interchange - Helical Scan Recording AIT-2 with MIC Format (Adopted ISO/IEC 18810:2001, first edition, 2001-02-01)

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-01-2004

Publisher

Canadian Standards Association

Section 1 - General
1 Scope
2 Conformance
3 Normative references
4 Definitions
5 Conventions and Notations
6 Acronyms
7 Environment and safety
Section 2 - Requirements for the case
8 Dimensional and mechanical characteristics of the case
Section 3 - Requirements for the unrecorded tape
9 Mechanical, physical and dimensional characteristics
of the tape
10 Magnetic recording characteristics
Section 4 - Requirements for an interchanged tape
11 Format
12 Method of recording
13 Track geometry
14 Recorded patterns
15 Format of a track
16 Layout of the tape
17 Housekeeping Frames
18 Content of the MIC
Annexes
A - Measurement of light transmittance
B - Measurement of Signal-to-Noise Ratio
C - Method for determining the nominal and the maximum
allowable recorded levels (pre-recording condition)
D - Representation of 16-bit words by 20-Channel bits patterns
E - Measurement of bit shift
F - Method of measuring the straightness of track edges
G - ECC calculation
H - Recommendations for transportation
J - Read-After-Write
K - Example of the content of a Basic Group No. 0
L - Examples of chip

Scope This International Standard specifies the physical and magnetic characteristics of an 8 mm wide magnetic tape cartridge containing a memory chip to enable physical interchange of such cartridges between drives. It also specifies the quality of the recorded signals, the recording method and the recorded format - called Advanced Intelligent Tape No.2 with Memory In Cartridge (AIT-2 with MIC) - thereby allowing data interchange between drives by means of such magnetic tape cartridges. The System Log are recorded in the MIC. This International Standard specifies two types of cartridge depending on the thickness of the magnetic tape contained in the case. Information interchange between systems also requires, at a minimum, agreement between the interchange parties upon the interchange code(s) and the specifications of the structure and labelling of the information on the interchanged cartridge.

DocumentType	Standard
ISBN	1-55397-297-X
Pages	108
ProductNote	Reconfirmed EN
PublisherName	Canadian Standards Association
Status	Current
Supersedes	CSA ISO/IEC 18810:2004

Standards	Relationship
ISO/IEC 18810:2001	Identical

IEC 60950:1999	Safety of information technology equipment
ISO/IEC 11576:1994	Information technology Procedure for the registration of algorithms for the lossless compression of data
ISO 1302:2002	Geometrical Product Specifications (GPS) Indication of surface texture in technical product documentation
ISO 527-3:1995	Plastics Determination of tensile properties Part 3: Test conditions for films and sheets

View more information

$536.99

Including GST where applicable

Product format

I agree to the DRM document license rules apply against the PDF selection made.

Please confirm that you agree to the document license rules for this document.

I agree to the document license rules .

Please confirm that you agree to the document license rules for this document.

Access your standards online with a subscription

Features

Simple online access to standards, technical information and regulations.
Critical updates of standards and customisable alerts and notifications.
Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

Get in touch with us

Log into your Account

CAN/CSA-ISO/IEC 18810-04 (R2012)

Current

Table of Contents

Abstract

Scope

General Product Information

International Equivalents

Standards Referencing This Book

Category

Subcategory

Access your standards online with a subscription