Name: DIN 16771-2:1988-12
Brand: DIN

DIN 16771-2:1988-12

Superseded

PLASTIC MOULDING MATERIALS; STYRENE/BUTADIENE (SB) MOULDING MATERIALS; PREPARATION OF SPECIMENS AND DETERMINATION OF THEIR PROPERTIES

Superseded date

01-10-1999

Published date

12-01-2013

Publisher

German Institute for Standardisation (Deutsches Institut für Normung)

Kein Inhaltsverzeichnis in der Norm vorhanden.

Outlines methods for preparing specimens and for determining characteristic properties of S/B moulding materials as defined in DIN 16 771 Pt 1 , and other properties, with the aim of achieving reproducible results when such properties are measured. Properties of products made of such materials are influenced by type of moulding material used, component design, and final condition of products, these in turn being dependent upon maufacturing conditions and type of subsequent treatment applied. Therefore, values obtained using the test methods set out are only applicable to specimens of the form specified, prepared as specified, and not to specimens of different dimensions or prepared by different procedures.

DocumentType	Standard
PublisherName	German Institute for Standardisation (Deutsches Institut für Normung)
Status	Superseded
SupersededBy	DIN EN ISO 2897-2:2004-05

DIN 7741-1:1986-12

PLASTIC MOULDING MATERIALS; POLYSTYRENE (PS) MOULDING MATERIALS; CLASSIFICATION AND DESIGNATION

DIN 53460:1976-12	TESTING OF PLASTICS; DETERMINATION OF THE VICAT SOFTENING TEMPERATURE OF THERMOPLASTICS
DIN 53448:1977-05	TESTING OF PLASTICS; TENSILE IMPACT TEST
DIN 53735:1988-02	TESTING OF PLASTICS; DETERMINATION OF THE MELT FLOW INDEX OF THERMOPLASTICS
DIN 53752:1980-12	TESTING OF PLASTICS; DETERMINATION OF THE COEFFICIENT OF LINEAR THERMAL EXPANSION
DIN 53728-4:1975-03	TESTING OF PLASTICS - DETERMINATION OF VISCOSITY OF SOLUTIONS, POLYETHYLEN (PE) AND POLYPROPYLENE (PP) IN DILUTE SOLUTION
DIN 53456:1973-01	TESTING OF PLASTICS; INDENTATION HARDNESS TEST
DIN 16771-1:1986-12	PLASTIC MOULDING MATERIALS - STYRENE/BUTADIENE (SB) MOULDING MATERIALS - CLASSIFICATION AND DESIGNATION
DIN 54811:1984-05	TESTING OF PLASTICS; DETERMINING THE FLUIDITY OF PLASTICS MELTS BY THE CAPILLARY RHEOMETER
ISO 180:2000	Plastics Determination of Izod impact strength
DIN 53461:1987-01	TESTING OF PLASTICS; DETERMINATION OF HEAT DEFLECTION TEMPERATURE UNDER LOAD
DIN 16770-2:1986-05	TESTING OF PLASTICS - TEST SPECIMENS OF THERMOPLASTIC MATERIALS - INJECTION MOULDING
DIN 50014:1985-07	CLIMATES AND THEIR TECHNICAL APPLICATION; STANDARD ATMOSPHERES