Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Performance requirements
  4.1 Reaction to fire
  4.2 Internal pressure strength and resistance to
      high temperature
  4.3 Dimensional tolerances
  4.4 Tightness
  4.5 Durability
  4.6 Dangerous substances
5 Test methods
  5.1 Reaction to fire
  5.2 Determination of the design pressure
  5.3 Dimensional tolerances
  5.4 Tightness and durability
6 Evaluation of conformity
  6.1 General
  6.2 Initial type testing
  6.3 Factory production control
  6.4 One-off products and products produced in
      very low quantities
Annex A (normative) Overall service (design)
                     coefficients
    A.1 General
    A.2 Overall service (design) coefficients buildings
Annex B (normative) Product standards for hot and cold
                        water installations Construction
                        Products Directive (CPD)
Annex C (normative) Standards for assessment of conformity
                        for hot and cold water installations
                        inside buildings
Annex ZA (informative) Clauses of this European Standard
                        addressing the provisions of the EU
                        Construction Products Directive (CPD)
    ZA.1 Scope and relevant characteristics
    ZA.2 Procedure for attestation of conformity of
         plastics pipes and fittings
    ZA.3 CE marking and labelling
Bibliography