1 Scope
2 Normative references
3 Terms and definitions
4 Abbreviations
5 Notation
6 Consideration of the emissions generated by MME
7 Selection of compliance criteria
   7.1 General
   7.2 Overview of physical quantities that can be used
        for exposure assessment
        7.2.1 Basic restrictions
        7.2.2 Reference levels
        7.2.3 Derived compliance criteria
   7.3 Exposure to multiple transmitting sources
   7.4 Criteria for selection of limits
8 Assessment procedure for MME
9 Determine basic characteristics of the MME
   9.1 Introduction
   9.2 Configuration of the MME
   9.3 Reference environment of the MME
   9.4 Arrangement of the MME
   9.5 Assessment positions and distances
   9.6 Power characteristics of the MME
   9.7 Intentional EM sources
10 Low power/Inherently compliant assessment methodologies
   10.1 Inherently compliant statement
   10.2 The low-power exclusion
        10.2.1 Consideration for an alternative low-power
               exclusion levels
   10.3 Extending EMF compliance to similar equipment
11 Methods for assessment against reference levels
   11.1 Identification of EMF quantities that are compliant
        in certain frequency ranges
        11.1.1 EMC compliance approach
        11.1.2 Low-frequency compliance of battery-fed MME
        11.1.3 Compliance with contact current reference
               levels
        11.1.4 Evaluation of product-specific or product-family
               specific criteria
   11.2 Overview of frequencies in which emissions can be
        identified as EMF compliant
   11.3 Selection of exposure parameters to be assessed
   11.4 Broadband measurement method
   11.5 Frequency selective measurement methods
   11.6 Test conditions
12 Methods for assessment against basic restrictions
   12.1 General
   12.2 Induced current assessment methods
        12.2.1 General
        12.2.2 Modeling
        12.2.3 Induced current measurements
   12.3 SAR assessment methods
        12.3.1 General
        12.3.2 SAR modeling
        12.3.3 SAR measurement methods
        12.3.4 Total radiated power evaluation
   12.4 Test conditions
13 Evaluation of compliance to limits
   13.1 Determination of uncertainties
   13.2 Compliance judgement
Annex A - Assessment distances, positions and surfaces
Annex B - Exposure limits
Annex C - Rationale for EMF compliance with contact current
Annex D - Overview of wired or wireless technologies that
          may be implemented in MME
Annex E - Alternative low-power exclusion levels
Annex F - Broadband measurement method
Annex G - Rationale for exemption of battery-operated MME
          for EMF assessment
Annex H - Total radiated power measurements in a RVC
Bibliography