Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Typical test procedures
   4.1 Basis
   4.2 Types of tests
5 General requirements for load testing
6 Testing of materials
   6.1 General
   6.2 Sampling
   6.3 Test methods
7 Testing of configurations and components
   7.1 General
   7.2 Tests to determine load bearing capacity,
         stiffness, and looseness
   7.3 Repeated loading
   7.4 Vibration tests
   7.5 Impact tests
8 Testing of system configurations
9 Documentation of test results
   9.1 General
   9.2 Content of test report
   9.3 Detailed instructions to the content
10 Evaluation of load bearing capacity, stiffness from
   testing metallic configurations and components
   10.1 General
   10.2 Approximation functions
   10.3 Dissipation of energy
   10.4 The ultimate value of the resistance r[a][u,i]
   10.5 The partial safety factor gamma[R2] depending
         upon the ductility
   10.6 Adjustment of the ultimate values r[a][u,i] to
         r[b][u,i] depending on deviations of the
         dimensions of the cross section
   10.7 Adjustment of the ultimate values r[b][u,i] to
         r[c][u,i] depending on the material properties
   10.8 Statistical determination of the basic
         characteristic value of the resistance R[k,b]
   10.9 Determination of the nominal characteristic value
         of the resistance R[k,nom]
   10.10 Evaluation of looseness, stiffness
Annex A (informative) Example for the determination of an
        approximation function, of the quotient q[theta]
        for the dissipation of energy and of the partial
        safety factor gamma [R2]
   A.1 Basis
   A.2 Approximation functions
   A.3 Dissipation of energy
   A.4 Partial safety factor gamma[R2]
Annex B (informative) Example for the statistical
        evaluation of test results and determination of
        the nominal characteristic value of the
        resistance
   B.1 Basis
   B.2 Calculations
Annex C (informative) Example for the evaluation of
        stiffness
   C.1 Basis
   C.2 Comparison of the averaged stiffnesses in
         positive C[pp] and negative C[mm] load
   C.3 Resulting stiffness
Bibliography