EN 60358-1:2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
22-02-2020
12-01-2013
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Service conditions
5 Ratings
6 Design requirements
7 Test conditions
8 Classification of tests
9 Routine tests
10 Type tests
11 Special tests - Mechanical strength test
12 Marking of the equipment
Annex A (informative) - Typical diagram of an equipment
Annex B (informative) - Partial discharge test circuit
and instrumentation
Annex C (normative) - Radio interference voltage -
Measurement circuit
Bibliography
Annex ZA (normative) - Normative references to international
publications with their corresponding European
publications
Pertains to: Capacitors, with rated voltage > 1000 V, connected line to ground with the low voltage terminal either permanently earthed or connected to devices, for applications listed hereunder and other similar uses.
| Committee |
SR 33
|
| DevelopmentNote |
Partially supersedes HD 597. (08/2012)
|
| DocumentType |
Standard
|
| PublisherName |
European Committee for Standards - Electrical
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| BS EN 60358-1:2012 | Identical |
| PN EN 60358-1 : 2013 AC 1 2015 | Identical |
| I.S. EN 60358-1:2012 | Identical |
| NF EN 60358-1 : 2013 | Identical |
| IEC 60358-1:2012 | Identical |
| NBN EN 60358-1 : 2012 | Identical |
| DIN EN 60358-1 : 2013 | Identical |
| NEN EN IEC 60358-1 : 2012 C1 2013 | Identical |
| VDE 0560-2 : 2013 | Identical |
| UNE-EN 60358-1:2012 | Identical |
| CEI EN 60358-2 : 2015 | COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 2: AC OR DC SINGLE-PHASE COUPLING CAPACITOR CONNECTED BETWEEN LINE AND GROUND FOR POWER LINE CARRIER-FREQUENCY (PLC) APPLICATION |
| I.S. EN 60358-3:2014 | COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 3: AC OR DC COUPLING CAPACITORS FOR HARMONIC-FILTERS APPLICATIONS |
| BS EN 60358-3:2014 | Coupling capacitors and capacitor dividers AC or DC coupling capacitors for harmonic-filters applications |
| I.S. EN 60143-2:2013 | SERIES CAPACITORS FOR POWER SYSTEMS - PART 2: PROTECTIVE EQUIPMENT FOR SERIES CAPACITOR BANKS (IEC 60143-2:2012 (EQV)) |
| BS EN 60143-2:2013 | Series capacitors for power systems Protective equipment for series capacitor banks |
| CEI EN 60143-2 : 2014 | SERIES CAPACITORS FOR POWER SYSTEMS - PART 2: PROTECTIVE EQUIPMENT FOR SERIES CAPACITOR BANKS |
| CEI EN 60358-3 : 2015 | COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 3: AC OR DC COUPLING CAPACITORS FOR HARMONIC-FILTERS APPLICATIONS |
| BS EN 60358-2:2013 | Coupling capacitors and capacitor dividers AC or DC single-phase coupling capacitor connected between line and ground for power line carrier-frequency (PLC) application |
| I.S. EN 60358-2:2013 | COUPLING CAPACITORS AND CAPACITOR DIVIDERS - PART 2: AC OR DC SINGLE-PHASE COUPLING CAPACITOR CONNECTED BETWEEN LINE AND GROUND FOR POWER LINE CARRIER-FREQUENCY (PLC) APPLICATION |
| EN 60358-2:2013 | Coupling capacitors and capacitor dividers - Part 2: AC or DC single-phase coupling capacitor connected between line and ground for power line carrier-frequency (PLC) application |
| EN 60143-2:2013 | Series capacitors for power systems - Part 2: Protective equipment for series capacitor banks |
| EN 60358-3:2014 | Coupling capacitors and capacitor dividers - Part 3: AC or DC coupling capacitors for harmonic-filters applications |
| IEC 60060-2:2010 | High-voltage test techniques - Part 2: Measuring systems |
| IEC 60038:2009 | IEC standard voltages |
| IEC 60270:2000+AMD1:2015 CSV | High-voltage test techniques - Partial discharge measurements |
| IEC 62155:2003 | Hollow pressurized and unpressurized ceramic and glass insulators for use in electrical equipment with rated voltages greater than 1 000 V |
| IEC 60050-601:1985 | International Electrotechnical Vocabulary (IEV) - Part 601: Generation, transmission and distribution of electricity - General |
| IEC 60422:2013 | Mineral insulating oils in electrical equipment - Supervision and maintenance guidance |
| IEC 60358-2:2013 | Coupling capacitors and capacitor dividers - Part 2: AC or DC single-phase coupling capacitor connected between line and ground for power line carrier-frequency (PLC) application |
| EN 60060-1:2010 | High-voltage test techniques - Part 1: General definitions and test requirements |
| IEC 60358-3:2013 | Coupling capacitors and capacitor dividers - Part 3: AC or DC coupling capacitor for harmonic-filters applications |
| IEC TR 62271-300:2006 | High-voltage switchgear and controlgear - Part 300: Seismic qualification of alternating current circuit-breakers |
| EN 61462:2007 | Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1 000 V - Definitions, test methods, acceptance criteria and design recommendations |
| EN 60270:2001/A1:2016 | HIGH-VOLTAGE TEST TECHNIQUES - PARTIAL DISCHARGE MEASUREMENTS (IEC 60270:2000/A1:2015) |
| IEC 60085:2007 | Electrical insulation - Thermal evaluation and designation |
| IEC 61462:2007 | Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1 000 V - Definitions, test methods, acceptance criteria and design recommendations |
| EN 60068-2-17:1994 | Environmental testing - Part 2: Tests - Test Q: Sealing |
| IEC 60068-2-17:1994 | Basic environmental testing procedures - Part 2-17: Tests - Test Q: Sealing |
| IEC 60358-1:2012 | Coupling capacitors and capacitor dividers - Part 1: General rules |
| EN 60071-1:2006/A1:2010 | INSULATION CO-ORDINATION - PART 1: DEFINITIONS, PRINCIPLES AND RULES |
| CISPR TR 18-2:2017 | Radio interference characteristics of overhead power lines and high-voltage equipment - Part 2: Methods of measurement and procedure for determining limits |
| IEC 60050-321:1986 | International Electrotechnical Vocabulary (IEV) - Part 321: Instrument transformers |
| IEC 61869-5:2011 | Instrument transformers - Part 5: Additional requirements for capacitor voltage transformers |
| IEC 60050-436:1990 | International Electrotechnical Vocabulary (IEV) - Part 436: Power capacitors |
| IEC 60060-1:2010 | High-voltage test techniques - Part 1: General definitions and test requirements |
| IEC 60071-1:2006+AMD1:2010 CSV | Insulation co-ordination - Part 1: Definitions, principles and rules |
| CISPR 16-1:1999+AMD1:2002 CSV | Specification for radio disturbance and immunity measuring apparatus and methods - Part 1: Radio disturbance and immunity measuring apparatus |
| EN 60038 : 2011 | CENELEC STANDARD VOLTAGES (IEC 60038:2009, MODIFIED) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.