Customer Support: 131 242

  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

EN 61319-1:1996/A11:1999

Current

Current

The latest, up-to-date edition.

INTERCONNECTIONS OF SATELLITE RECEIVING EQUIPMENT - PART 1: EUROPE

Amendment of

EN 61319-1:1996

Published date

28-04-1999

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Explanation of terms and abbreviations
4 Interface requirements for polarizers and
  polarswitchers
  4.1 Mechanical polarizers (optional)
  4.2 Magnetic polarizers (using the Faraday effect)
       4.2.1 Polarizers for two orthogonal polarizations
       4.2.2 Polarizers for four polarizations
  4.3 Polarswitchers
5 Interface requirements for low-noise block
  converters (LNB)
  5.1 Characteristic impedance of the first intermediate
       frequency (IF) output
  5.2 Interface between the LNB (outdoor part) and the satellite
       receiver (indoor part), case 1: one IF input signal and
       one two-state control command
       5.2.1 Single-band block converters
       5.2.2 Dual-band block converters
       5.2.3 Combination of dual-band block converter with
             polarswitcher
  5.3 Interface between the LNB (outdoor part) and the
       satellite receiver (indoor part) case 2: two IF
       input signals and internal two-state control command
  5.4 Connectors
6 Interface requirements for switching between different antenna
  sources or antenna positions
  6.1 Electrical matching values for the actuator motor supply
  6.2 Electrical matching values for the antenna position sensor
  6.3 Interface between the antenna position control unit and
       the satellite receiver
       6.3.1 Circular connector
       6.3.2 Domestic Digital Bus (D2B)
7 Interface requirements for satellite receivers and external
  decoders, descramblers and conditional access systems
8 Interface requirements for Digital Satellite Radio (DSR)
  receivers
  8.1 Configuration of receiving equipment
       8.1.1 Direct reception of radio only
       8.1.2 Direct reception of radio and television
       8.1.3 Cable reception
  8.2 Audio-frequency outputs of DSR receivers
Annex A (informative) Interconnections between a satellite
                      receiver and a decoder
Annex ZA (normative) Normative references to international
                      publications with their corresponding
                      European publications
Annex ZB (normative) Communication between the satellite
                      receiver and the peripheral equipment using
                      the Digital Satellite Equipment Control
                      bus (DiSEqC)
  ZB.1 Scope
  ZB.2 Normative references
  ZB.3 Basic principle of the extended signalling method
  ZB.4 Typical applications
  ZB.5 Combination of conventional and new signalling messages
  ZB.6 Simple Tone Burst control signal
  ZB.7 Method of data bit signalling
  ZB.8 Structure of a DiSEqC message
  ZB.9 Cascaded DiSEqC devices
  ZB.10 Power management
  ZB.11 Reset at power set-up
  ZB.12 Reset when using loop-through tuners
  ZB.13 D.C. voltage rise and settling time
  ZB.14 Time sequences for DiSEqC messages
  ZB.15 Frequency allocation of the local oscillators
  ZB.16 Characteristics of the signalling d.c. voltage
  ZB.17 Characteristics of the 22 kHz signalling tone
  ZB.18 Transport of the 22 kHz tone
  ZB.19 IPR, trademark and logo
Figures

Covers standardization of interconnections and matching values for satellite receivers for individual television and sound radio broadcast reception in the 10,70 GHz to 12,75 GHz band

Committee
TC 100X
DocumentType
Standard
PublisherName
European Committee for Standards - Electrical
Status
Current

CEI EN 60728-3 : 2011 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 3: ACTIVE WIDEBAND EQUIPMENT FOR CABLE NETWORKS
CEI EN 60728-5 : 2016 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 5: HEADEND EQUIPMENT
PD CLC/TS 50607:2013 Satellite signal distribution over a single coaxial cable. Second generation
CEI EN 50607 : 2015 SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE - SECOND GENERATION
BS EN 50201:2001 Interfaces for DVB-IRD
I.S. EN 50607:2015 SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE - SECOND GENERATION
UNE-EN 60728-3:2012 Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for cable networks
EN 50256:1998 Characteristics of DVB receivers
EN 50201:2001 Interfaces for DVB-IRD
EN 50494:2007 Satellite signal distribution over a single coaxial cable in single dwelling installations
06/30150711 DC : 0 BS EN 50494 - SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE IN SINGLE DWELLING INSTALLATIONS
I.S. EN 50083-3:2002 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 3: ACTIVE WIDEBAND EQUIPMENT FOR COAXIAL CABLE NETWORKS
BS EN 50083-3:1999 Cabled distribution systems for television and sound signals Active wideband equipment for coaxial cable networks
CEI EN 50201 : 2002 INTERFACES FOR DVB-IRD
I.S. EN 60728-3:2011 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 3: ACTIVE WIDEBAND EQUIPMENT FOR CABLE NETWORKS
I.S. EN 50494:2007 SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE IN SINGLE DWELLING INSTALLATIONS
BS EN 50494:2007 Satellite signal distribution over a single coaxial cable in single dwelling installations
BS EN 60728-5:2008 Cable networks for television signals, sound signals and interactive services Headend equipment
S.R. CLC/TS 50607:2013 SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE - SECOND GENERATION
I.S. EN 50256:1998 CHARACTERISTICS OF DVB RECEIVERS
BS EN 60728-3:2011 Cable networks for television signals, sound signals and interactive services Active wideband equipment for cable networks
BS EN 50256:1998 Characteristics of DVB receivers
CEI EN 50494 : 2008 SATELLITE SIGNAL DISTRIBUTION OVER A SINGLE COAXIAL CABLE IN SINGLE DWELLING INSTALLATIONS
I.S. EN 50201:2002 INTERFACES FOR DVB-IRD
CEI EN 50256 : 1999 CHARACTERISTICS OF DVB RECEIVERS
CLC/TS 50607:2013 Satellite signal distribution over a single coaxial cable - Second generation
BS EN 50607:2015 Satellite signal distribution over a single coaxial cable. Second generation
I.S. EN IEC 60728-3:2018 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 3: ACTIVE WIDEBAND EQUIPMENT FOR CABLE NETWORKS (TA 5)
TR 101 790 : 1.4.1 DIGITAL VIDEO BROADCASTING (DVB); INTERACTION CHANNEL FOR SATELLITE DISTRIBUTION SYSTEMS; GUIDELINES FOR THE USE OF EN 301 790
EN IEC 60728-3:2018 Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for cable networks (TA 5)
I.S. EN 60728-5:2016 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 5: HEADEND EQUIPMENT
EN 303 372-1 : 1.1.1 SATELLITE EARTH STATIONS AND SYSTEMS (SES); SATELLITE BROADCAST RECEPTION EQUIPMENT; HARMONISED STANDARD COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF THE DIRECTIVE 2014/53/EU; PART 1: OUTDOOR UNIT RECEIVING IN THE 10,7 GHZ TO 12,75 GHZ FREQUENCY BAND
EN 50083-3:2002 Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for coaxial cable networks
EN 60728-5:2016 Cable networks for television signals, sound signals and interactive services - Part 5: Headend equipment
EN 50607:2015 Satellite signal distribution over a single coaxial cable - Second generation

EN 61030:1993 Audio, video and audiovisual systems - Domestic Digital Bus (D2B)
EN 60065:2014/AC:2017-01 AUDIO, VIDEO AND SIMILAR ELECTRONIC APPARATUS - SAFETY REQUIREMENTS (IEC 60065:2014/COR2:2016)
HD 134.2 : 200S2 RADIO-FREQUENCY CONNECTORS - COAXIAL UNMATCHED CONNECTOR
IEC 60169-2:1965 Radio-frequency connectors. Part 2: Coaxial unmatched connector
IEC 60130-9:2011 Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment
HD 483.15 : 200S4 SOUND SYSTEM EQUIPMENT - PREFERRED MATCHING VALUES FOR THE INTERCONNECTION OF SOUND SYSTEM COMPONENTS
HD 483.11 : 200S3 SOUND SYSTEM EQUIPMENT - APPLICATION OF CONNECTORS FOR THE INTERCONNECTION OF SOUND SYSTEM COMPONENTS
IEC 60933-4:1994 Audio, video and audiovisual systems - Interconnections and matching values - Part 4: Connector and cordset for domestic digital bus (D2B)
IEC 60958:1989 Digital audio interface
EN 60933-4:1994 Audio, video and audiovisual systems - Interconnections and matching values - Part 4: Connector and cordset for domestic digital bus (D2B)
IEC 60268-15:1996 Sound system equipment - Part 15: Preferred matching values for the interconnection of sound system components.
EN 60130-9:2011 Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment
IEC 61030:1991 Audio, video and audiovisual systems - Domestic Digital Bus (D2B)
EN 60169-24:1993 Radio-frequency connectors - Part 24: Radio-frequency coaxial connectors with screw coupling, typically for use in 75 ohm cable distribution systems (Type F)
IEC 60169-24:1991 Radio-frequency connectors - Part 24: Radio-frequency coaxial connectors with screw coupling, typically for use in 75 ohm cable distribution systems (Type F)
EN 60958:1990/A2:1995 DIGITAL AUDIO INTERFACE
IEC 60268-11:1987 Sound system equipment. Part 11: Application of connectors for the interconnection of sound system components
IEC 60807-9:1993 Rectangular connectors for frequencies below 3 MHz - Part 9: Detail specification for a range of peritelevision connectors

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more