Customer Support: 131 242

  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

EN 61606 : 1997

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

AUDIO AND AUDIOVISUAL EQUIPMENT - DIGITAL AUDIO PARTS - BASIC METHODS OF MEASUREMENT OF AUDIO CHARACTERISTICS

Superseded date

01-01-2004

Published date

12-01-2013

1 General
    1.1 Scope
    1.2 Normative references
2 Definitions, explanation of terms and abbreviations
    2.1 Definitions
    2.2 Explanation of terms
    2.3 Abbreviation
3 Measuring conditions
    3.1 Environmental conditions
    3.2 Power supply
    3.3 Test signal
    3.4 Test signal source
    3.5 Standard input conditions for the EUT
    3.6 Standard output conditions for the EUT
    3.7 Standard settings of controls
    3.8 Pre-conditioning
    3.9 Test instruments
4 Methods of measurement (digital in/analogue out)
    4.1 Output source impedance
    4.2 Output voltage and power
    4.3 Frequency response
    4.4 Gain difference between channels
    4.5 Phase difference between channels
    4.6 Phase linearity
    4.7 Total delay through the EUT
    4.8 Polarity
    4.9 Level non-linearity
    4.10 Distortion and noise
    4.11 Dynamic range
    4.12 Idle channel noise level (signal-to-noise ratio)
    4.13 Intermodulation distortion
    4.14 Out-of-band noise ratio
    4.15 Stereophonic separation
5 Classification of the characteristics to be specified
Tables
1 Frequencies used for measurements
2 Pass band of typical 1/2 fs filters unless otherwise
    specified
3 Pass band of out-of-band filters
4 Measurement frequencies for band pass filters (Hz)
5 Example of the presentation of the measured values
6 Classification of the characteristics to be specified
Figures
1 Waveform
2 Circuit arrangement for measuring output source impedance
3 Circuit arrangement for measuring output voltage
    and power
4 Circuit arrangement for measuring frequency response
5 Circuit arrangement for measuring phase difference
6 Circuit arrangement for measuring total delay
7 Circuit arrangement for measuring polarity
8 Circuit arrangement for measuring non-linearity
9 Circuit arrangement for measuring distortion and
    noise
10 Circuit arrangement for measuring dynamic range
11 Circuit arrangement for measuring idle channel noise
    level
12 Circuit arrangement for measuring stereophonic
    separation
Annexes
A Compact disc test discs
B Bibliography
ZA (normative) Normative references to international
   publications with their corresponding European
   publications

Applies to the basic measurement methods of the audio characteristics of the digital audio and audiovisual equipment (for both consumer and professional use). Covers the usual conditions and procedures for use in measuring performance characteristics of equipment with an audio bandwidth approximately one half of the sampling frequency of a system, when the audio information is processed in digital data form. Does not apply to systems including bit-rate reduced digital audio signals.

Committee
SR 100
DocumentType
Standard
PublisherName
European Committee for Standards - Electrical
Status
Superseded
SupersededBy

Standards Relationship
NF EN 61606 : 1997 Identical
IEC 61606:1997 Identical
NBN EN 61606 : 1998 Identical
NEN EN IEC 61606 : 1997 Identical
I.S. EN 61606:1999 Identical
SN EN 61606 : 1997 Identical
BS EN 61606:1997 Identical
CEI EN 61606 : 1ED 1998 Identical
DIN EN 61606:1997-07 Identical
UNE-EN 61606:1997 Identical

02/205172 DC : DRAFT JUN 2002 IEC 62104. ED.2.0 - CHARACTERISTICS OF DAB (DIGITAL AUDIO BROADCAST) RECEIVERS
EN 62121:2001 Methods of measurement for minidisc recorders/players
CEI EN 62104 : 2009 CHARACTERISTICS OF DAB RECEIVERS
BS EN 62104:2007 Characteristics of DAB receivers
I.S. EN 62104:2007 CHARACTERISTICS OF DAB RECEIVERS
EN 62104:2007 Characteristics of DAB receivers
BS EN 62121:2001 Methods of measurement for minidisc recorders/players
I.S. EN 50248:2001 CHARACTERISTICS OF DAB RECEIVERS
BS EN 50248 : 2001 CHARACTERISTICS OF DAB RECEIVERS
EN 50248 : 2001 COR 2007 CHARACTERISTICS OF DAB RECEIVERS

IEC 60038:2009 IEC standard voltages
IEC 60268-3:2013 Sound system equipment - Part 3: Amplifiers
ISO 266:1997 Acoustics — Preferred frequencies
IEC 60107-5:1992+AMD1:1999 CSV Recommended methods of measurements on receivers for television broadcast transmissions - Part 5: Electrical measurements on multichannel sound television receivers using the NICAM two-channel digital sound-system
IEC 60958:1989 Digital audio interface
IEC 60268-15:1996 Sound system equipment - Part 15: Preferred matching values for the interconnection of sound system components.
IEC 60268-1:1985 Sound system equipment. Part 1: General
IEC 60651:1979+AMD1:1993+AMD2:2000 CSV Sound level meters

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more