We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • EN ISO 6413 : 1994

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    TECHNICAL DRAWINGS - REPRESENTATION OF SPLINES AND SERRATIONS

    Available format(s): 

    Superseded date:  05-03-2022

    Language(s): 

    Published date:  12-01-2013

    Publisher:  Comite Europeen de Normalisation

    Add to Watchlist
    Pure ENs are not available for sale, please purchase a suitable national adoption

    Sorry this product is not available in your region.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    1 Scope
    2 Normative references
    3 Definitions
    4 Designation
    5 Complete representation of spline joints
    6 Simplified representation
    7 Assembly drawings
    Annex A (normative) Proportions and dimensions of graphical
            symbols

    Abstract - (Show below) - (Hide below)

    ALSO NUMBERED AS BS 308 SECTION 1.9 1995 Specifies the rules and graphical symbols for the representation of splines and serrations on technical drawings. Specifies two methods of representation: simplified representation; true representation. Applies to detail drawings of the parts (shafts and hubs) and to assembly drawings of joints.

    General Product Information - (Show below) - (Hide below)

    Document Type Standard
    Publisher Comite Europeen de Normalisation
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    BS 308-1(1993) : 1993 ENGINEERING DRAWING PRACTICE - RECOMMENDATIONS FOR GENERAL PRINCIPLES
    BS 5686(1986) : 1986 SPECIFICATION FOR STRAIGHT-SIDED SPLINES FOR CYLINDRICAL SHAFTS: METRIC NOMINAL DIMENSIONS, TOLERANCES AND GAUGING REQUIREMENTS
    ISO 3098-1:2015 Technical product documentation Lettering Part 1: General requirements
    ISO 14:1982 Straight-sided splines for cylindrical shafts with internal centering Dimensions, tolerances and verification
    ISO 3461-2:1987 General principles for the creation of graphical symbols Part 2: Graphical symbols for use in technical product documentation
    BS 6186-1(1981) : 1981 SPECIFICATION FOR STRAIGHT CYLINDRICAL INVOLUTE SPLINES: METRIC MODULE, SIDE FIT - DIMENSIONS AND TOLERANCES
    ISO 128:1982 Technical drawings — General principles of presentation
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective