I.S. EN 15383:2012
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
PLASTICS PIPING SYSTEMS FOR DRAINAGE AND SEWERAGE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON POLYESTER RESIN (UP) - MANHOLES AND INSPECTION CHAMBERS
Hardcopy , PDF
23-10-2013
English
11-01-2013
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 General requirements
5 Geometrical characteristics
6 Mechanical characteristics
7 Leak-tightness of manholes and inspection chambers and
their joints
8 Minimum required marking
9 Ancillary products
10 Dangerous substances
11 Manufacturer's installation recommendations
12 Evaluation of conformity
Annex A (normative) - Determination of the longitudinal
compressive properties measured on prism shaped test
pieces
Annex B (normative) - Determination of the resistance of
installed steps to vertical or horizontal loading
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.