We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • I.S. EN 60296:2012

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    FLUIDS FOR ELECTROTECHNICAL APPLICATIONS - UNUSED MINERAL INSULATING OILS FOR TRANSFORMERS AND SWITCHGEAR (IEC 60296:2012 (EQV))

    Available format(s):  Hardcopy, PDF

    Superseded date:  17-09-2020

    Language(s):  English

    Published date:  01-01-2012

    Publisher:  National Standards Authority of Ireland

    Add to Watchlist

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    INTRODUCTION
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Properties of oil
    5 Classification, identification, general delivery
      requirements and sampling
    6 Properties, their significance and test methods
    7 Specific requirements for special applications
    Annex A (informative) - Potentially corrosive sulphur
    Bibliography
    Annex ZA (normative) - Normative references to
             international publications with their
             corresponding European publications
    Annex ZB (normative) - Special national conditions

    Abstract - (Show below) - (Hide below)

    Covers specifications and test methods for unused mineral insulating oils.

    General Product Information - (Show below) - (Hide below)

    Development Note For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By
    Supersedes

    Standards Referencing This Book - (Show below) - (Hide below)

    ISO 3016:1994 Petroleum products Determination of pour point
    ISO 2719:2016 Determination of flash point Pensky-Martens closed cup method
    EN 60156 : 1995 INSULATING LIQUIDS - DETERMINATION OF THE BREAKDOWN VOLTAGE AT POWER FREQUENCY - TEST METHOD
    IEC 62021-1:2003 Insulating liquids - Determination of acidity - Part 1: Automatic potentiometric titration
    EN 60422:2013 Mineral insulating oils in electrical equipment - Supervision and maintenance guidance
    IEC 62021-2:2007 Insulating liquids - Determination of acidity - Part 2: Colourimetric titration
    IEC 61125:1992 INSULATING LIQUIDS - TEST METHODS FOR OXIDATION STABILITY - TEST METHOD FOR EVALUATING THE OXIDATION STABILITY OF INSULATING LIQUIDS IN THE DELIVERED STATE
    ISO 3675:1998 Crude petroleum and liquid petroleum products Laboratory determination of density Hydrometer method
    EN ISO 3104:1996 PETROLEUM AND ITS PRODUCTS - KINEMATIC VISCOSITY - PETROLEUM PRODUCTS - TRANSPARENT AND OPAQUE LIQUIDS - DETERMINATION OF KINEMATIC VISCOSITY AND CALCULATION OF DYNAMIC VISCOSITY
    IEC 60422:2013 Mineral insulating oils in electrical equipment - Supervision and maintenance guidance
    IEC 60156:1995 INSULATING LIQUIDS - DETERMINATION OF THE BREAKDOWN VOLTAGE AT POWER FREQUENCY - TEST METHOD
    EN 61125:1993/A1:2004 UNUSED HYDROCARBON-BASED INSULATING LIQUIDS - TEST METHODS FOR EVALUATING THE OXIDATION STABILITY
    EN ISO 12185 : 1996 CRUDE PETROLEUM AND PETROLEUM PRODUCTS - DETERMINATION OF DENSITY - OSCILLATING U-TUBE METHOD
    EN 14210 : 2003 SURFACE ACTIVE AGENTS - DETERMINATION OF INTERFACIAL TENSION OF SOLUTIONS OF SURFACE ACTIVE AGENTS BY THE STIRRUP OR RING METHOD
    EN 61619 : 1997 INSULATING LIQUIDS - CONTAMINATION BY POLYCHLORINATED BIPHENYLS (PCBS) - METHOD OF DETERMINATION BY CAPILLARY COLUMN GAS CHROMATOGRAPHY
    HD 488 : 200S3 GASSING OF INSULATING LIQUIDS UNDER ELECTRICAL STRESS AND IONIZATION
    ISO 6247:1998 Petroleum products — Determination of foaming characteristics of lubricating oils
    EN ISO 14596 : 2007 PETROLEUM PRODUCTS - DETERMINATION OF SULFUR CONTENT - WAVELENGTH-DISPERSIVE X-RAY FLUORESCENCE SPECTROMETRY
    IEC 62535:2008 Insulating liquids - Test method for detection of potentially corrosive sulphur in used and unused insulating oil
    IEC 60475:2011 Method of sampling insulating liquids
    EN 61620 : 1999 INSULATING LIQUIDS - DETERMINATION OF THE DIELECTRIC DISSIPATION FACTOR BY MEASUREMENT OF THE CONDUCTANCE AND CAPACITANCE - TEST METHOD
    IEC 61868:1998 MINERAL INSULATING OILS - DETERMINATION OF KINEMATIC VISCOSITY AT VERY LOW TEMPERATURES
    EN ISO 3675 : 1998 CRUDE PETROLEUM AND LIQUID PETROLEUM PRODUCTS - LABORATORY DETERMINATION OF DENSITY - HYDROMETER METHOD
    EN 61198 : 1994 MINERAL INSULATING OILS - METHODS FOR THE DETERMINATION OF 2-FURFURAL AND RELATED COMPOUNDS
    EN 60814 : 1997 INSULATING LIQUIDS - OIL-IMPREGNATED PAPER AND PRESSBOARD - DETERMINATION OF WATER BY AUTOMATIC COULOMETRIC KARL FISCHER TITRATION
    EN 62021-2 : 2007 INSULATING LIQUIDS - DETERMINATION OF ACIDITY - PART 2: COLOURIMETRIC TITRATION
    EN 62535 : 2009 INSULATING LIQUIDS - TEST METHOD FOR DETECTION OF POTENTIALLY CORROSIVE SULPHUR IN USED AND UNUSED INSULATING OIL
    EN 60970:2007/corrigendum:2008 INSULATING LIQUIDS - METHODS FOR COUNTING AND SIZING PARTICLES
    ISO 12185:1996 Crude petroleum and petroleum products Determination of density Oscillating U-tube method
    IEC 60970:2007 Insulating liquids - Methods for counting and sizing particles
    IEC 62697-1:2012 Test methods for quantitative determination of corrosive sulfur compounds in unused and used insulating liquids - Part 1: Test method for quantitative determination of dibenzyldisulfide (DBDS)
    EN 60247 : 2004 INSULATING LIQUIDS - MEASUREMENT OF RELATIVE PERMITTIVITY, DIELECTRIC DISSIPATION FACTOR (TAN DELTA) AND D.C. RESISTIVITY
    IEC 60666:2010 Detection and determination of specified additives in mineral insulating oils
    IEC 61620:1998 INSULATING LIQUIDS - DETERMINATION OF THE DIELECTRIC DISSIPATION FACTOR BY MEASUREMENT OF THE CONDUCTANCE AND CAPACITANCE - TEST METHOD
    IEC 60867:1993 Insulating liquids - Specifications for unused liquids based on synthetic aromatic hydrocarbons
    IEC 60814:1997 Insulating liquids - Oil-impregnated paper and pressboard - Determination of water by automatic coulometric Karl Fischer titration
    IEC 60076-2:2011 Power transformers - Part 2: Temperature rise for liquid-immersed transformers
    EN ISO 2719:2016 DETERMINATION OF FLASH POINT - PENSKY-MARTENS CLOSED CUP METHOD (ISO 2719:2016)
    IEC 60247:2004 Insulating liquids - Measurement of relative permittivity, dielectric dissipation factor (tan d) and d.c. resistivity
    EN 61868 : 1999 MINERAL INSULATING OILS - DETERMINATION OF KINEMATIC VISCOSITY AT VERY LOW TEMPERATURES
    ISO 14596:2007 Petroleum products Determination of sulfur content Wavelength-dispersive X-ray fluorescence spectrometry
    ASTM D 7150 : 2013 : REDLINE Standard Test Method for the Determination of Gassing Characteristics of Insulating Liquids Under Thermal Stress
    IEC 61619:1997 Insulating liquids - Contamination by polychlorinated biphenyls (PCBs) - Method of determination by capillary column gas chromatography
    EN 60076-2:2011 POWER TRANSFORMERS - PART 2: TEMPERATURE RISE FOR LIQUID-IMMERSED TRANSFORMERS
    IEC 61198:1993 Mineral insulating oils - Methods for the determination of 2-furfural and related compounds
    EN 62021-1 : 2003 INSULATING LIQUIDS - DETERMINATION OF ACIDITY - PART 1: AUTOMATIC POTENTIOMETRIC TITRATION
    EN 60475 : 2011 Method of sampling insulating liquids
    EN 60666 : 2010 DETECTION AND DETERMINATION OF SPECIFIED ADDITIVES IN MINERAL INSULATING OILS
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective