I.S. EN 62193:2003
Current
The latest, up-to-date edition.
Hardcopy , PDF
English
01-01-2003
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Requirements
5.1 Safety
5.2 General
5.3 Requirements for the lock assembly and end caps
5.4 Surface finish
5.5 Dimensional requirements
5.6 Marking
5.7 Instructions for use
6 Type testing
6.1 General
6.2 Visual inspection and dimensional check
6.3 Durability of markings
6.4 Dielectric tests
6.5 Mechanical tests
7 Quality assurance plan
8 Modifications
Annex A (informative) Selection of the length of the
tip section of the tool
Annex B (normative) Suitable for live working; double
triangle (IEC-60417-5216:2002-10)
Annex C (normative) Chronology of tests
Annex D (normative) Quality assurance plan
Annex E (normative) Acceptance tests
Annex F (informative) In-service recommendations
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.