Preview

Connectors for electrical and electronic equipment - Product requirements - Part 2-010: Circular connectors - Detail specification for connectors with outer or inner push-pull locking mechanism, based on mating interfaces according to IEC 61076-2-101, IEC 61076-2-109, IEC 61076- 2-111 and IEC 61076-2-113

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

16-08-2021

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Technical information
5 Dimensional information
6 Characteristics
7 Test schedule
Annex A (informative) Diameter and position of the female connector body
Annex B (informative) Example for L-coded connector and comparison between screw- and inner push-pull-locking
Annex C (informative) Styles of female free connectors to extend free male cable connectors

This part of IEC 61076-2 specifies circular connectors with a push-pull locking mechanism of a size derived from, and thus being compatible with M12 screw-locking connectors (free connectors with screw-locking according to IEC 61076-2-101, IEC 61076-2-109, IEC 61076-2-111 or IEC 61076-2-113 are compatible with push-pull fixed interfaces according to this document) and with mating interfaces according to IEC 61076-2-101, IEC 61076-2-109, IEC 61076-2-111 (except codings E in general and coding F for inner push-pull) or IEC 61076-2-113.

Committee	TC 48
DocumentType	Standard
ISBN	978-2-8322-9812-1
Pages	118
ProductNote	The date of any NSAIprevious adoption may not matchthe date of its original CEN/CENELEC document.
PublisherName	National Standards Authority of Ireland
Status	Current