FOREWORD
INTRODUCTION
0 Principles of this product safety standard
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
4 General requirements
5 Electrically-caused injury
6 Electrically-caused fire
7 Injury caused by hazardous substances
8 Mechanically-caused injury
9 Thermal burn injury
10 Radiation
Annex A (informative) Examples of equipment within the scope of this document
Annex B (normative) Normal operating condition tests, abnormal operating condition tests and single fault condition tests
Annex C (normative) UV radiation
Annex D (normative) Test generators
Annex E (normative) Test conditions for equipment containing audio amplifiers
Annex F (normative) Equipment markings, instructions, and instructional safeguards
Annex G (normative) Components
Annex H (normative) Criteria for telephone ringing signals
Annex I (informative) Overvoltage categories (see IEC 60364-4-44)
Annex J (normative) Insulated winding wires for use without interleaved insulation
Annex K (normative) Safety interlocks
Annex L (normative) Disconnect devices
Annex M (normative) Equipment containing batteries and their protection circuits
Annex N (normative) Electrochemical potentials (V)
Annex O (normative) Measurement of creepage distances and clearances
Annex P (normative) Safeguards against conductive objects
Annex Q (normative) Circuits intended for interconnection with building wiring
Annex R (normative) Limited short-circuit test
Annex S (normative) Tests for resistance to heat and fire
Annex T (normative) Mechanical strength tests
Annex U (normative) Mechanical strength of CRTs and protection against the effects of implosion
Annex V (normative) Determination of accessible parts
Annex W (informative) Comparison of terms introduced in this document
Annex X (normative) Alternative method for determining clearances for insulation in circuits connected to an AC mains not exceeding 420 V peak (300 V RMS)
Annex Y (normative) Construction requirements for outdoor enclosures
Bibliography