Customer Support: 131 242

  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

I.S. EN IEC 62485-2:2018

Current
Current

The latest, up-to-date edition.

SAFETY REQUIREMENTS FOR SECONDARY BATTERIES AND BATTERY INSTALLATIONS - PART 2: STATIONARY BATTERIES
Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

22-05-2018

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National Foreword
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Protection against electric shock
5 Disconnection and separation
6 Prevention of short circuits and protection from
   other effects of electric current
7 Provisions against explosion hazards
8 Provision against electrolyte hazard
9 Accommodation, housing
10 Charge current requirements
11 Identification labels, warning notices and instructions
   for use, installation and maintenance
12 Transportation, storage, disposal and environmental
   aspects
13 Inspection and monitoring
Annex A (informative) - Charging methods and modes of
        operation
Annex B (informative) - Calculation of safety distance d to
        protect against explosion hazards
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Pertains to stationary secondary batteries and battery installations with a maximum voltage of DC 1500 V (nominal) and describes the principal measures for protections against hazards generated from: - electricity, - gas emission, - electrolyte.

Committee
TC 21
DevelopmentNote
Supersedes I.S. EN 50272-2. For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (06/2018)
DocumentType
Standard
ISBN
978-2-88910-996-8
Pages
90
ProductNote
The date of any NSAI previous adoption may not match the date of its original CEN/CENELEC document.
PublisherName
National Standards Authority of Ireland
Status
Current
Supersedes

Standards Relationship
IEC 62485-2:2010 Identical
EN IEC 62485-2:2018 Identical

IEC 60950-1:2005+AMD1:2009+AMD2:2013 CSV Information technology equipment - Safety - Part 1: General requirements
IEC 60364-5-54:2011 Low-voltage electrical installations - Part 5-54: Selection and erection of electrical equipment - Earthing arrangements and protective conductors
IEC 60364-4-43:2008 Low-voltage electrical installations - Part 4-43: Protection for safety - Protection against overcurrent
IEC 62259:2003 Secondary cells and batteries containing alkaline or other non-acid electrolytes - Nickel-cadmium prismatic secondary single cells with partial gas recombination
HD 60364-4-43:2010 Low-voltage electrical installations - Part 4-43: Protection for safety - Protection against overcurrent
IEC 60896-11:2002 Stationary lead-acid batteries - Part 11: Vented types - General requirements and methods of tests
IEC 60364-4-41:2005+AMD1:2017 CSV Low voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
EN 60623:2017 Secondary cells and batteries containing alkaline or other non-acid electrolytes - Vented nickel-cadmium prismatic rechargeable single cells
IEC TR 61438:1996 Possible safety and health hazards in the use of alkaline secondary cells and batteries - Guide to equipment manufacturers and users
IEC TS 61201:2007 Use of conventional touch voltage limits - Application guide
EN 61660-2:1997 Short-circuit currents in d.c. auxiliary installations in power plants and substations - Part 2: Calculation of effects
IEC 60896-21:2004 Stationary lead-acid batteries - Part 21: Valve regulated types - Methods of test
IEC 60364-5-53:2001+AMD1:2002+AMD2:2015 CSV Electrical installations of buildings - Part 5-53: Selection and erection of electrical equipment - Isolation, switching and control
HD 60364-4-41:2017/A11:2017 LOW-VOLTAGE ELECTRICAL INSTALLATIONS - PART 4-41: PROTECTION FOR SAFETY - PROTECTION AGAINST ELECTRIC SHOCK
IEC 61660-2:1997 Short-circuit currents in d.c. auxiliary installations in power plants and substations - Part 2: Calculation of effects
EN 62259:2004 Secondary cells and batteries containing alkaline or other non-acid electrolytes - Nickel-cadmium prismatic secondary single cells with partial gas recombination
IEC 60079-10-1:2015 Explosive atmospheres - Part 10-1: Classification of areas - Explosive gas atmospheres
IEC 60050-482:2004 International Electrotechnical Vocabulary (IEV) - Part 482: Primary and secondary cells and batteries
IEC 60364-1:2005 Low-voltage electrical installations - Part 1: Fundamental principles, assessment of general characteristics, definitions
IEC TR 62060:2001 Secondary cells and batteries - Monitoring of lead acid stationary batteries - User guide
EN 61660-1:1997 Short-circuit currents in d.c. auxiliary installations in power plants and substations - Part 1: Calculation of short-circuit currents
IEC TR 60755:2008 General requirements for residual current operated protective devices
IEC 61340-4-1:2003+AMD1:2015 CSV Electrostatics - Part 4-1: Standard test methods for specific applications - Electrical resistance of floor coverings and installed floors
IEC 60529:1989+AMD1:1999+AMD2:2013 CSV Degrees of protection provided by enclosures (IP Code)
IEC 61660-1:1997 Short-circuit currents in d.c. auxiliary installations in power plants and substations - Part 1: Calculation of short-circuit currents
IEC 60896-22:2004 Stationary lead-acid batteries - Part 22: Valve regulated types - Requirements
EN 60896-11:2003 Stationary lead-acid batteries - Part 11: Vented types - General requirements and methods of tests
EN 60664-1:2007 Insulation coordination for equipment within low-voltage systems - Part 1: Principles, requirements and tests
IEC 60900:2012 Live working - Hand tools for use up to 1 000 V a.c. and 1 500 V d.c.
EN 61340-4-1:2004/A1:2015 ELECTROSTATICS - PART 4-1: STANDARD TEST METHODS FOR SPECIFIC APPLICATIONS - ELECTRICAL RESISTANCE OF FLOOR COVERINGS AND INSTALLED FLOORS (IEC 61340-4-1:2003/A1:2015)
IEC 60364-7-706:2005 Low-voltage electrical installations - Part 7-706: Requirements for special installations or locations - Conducting locations with restricted movement
EN 60900:2012 LIVE WORKING - HAND TOOLS FOR USE UP TO 1000 V A.C. AND 1500 V D.C. (IEC 60900:2012)
EN 60622:2003 Secondary cells and batteries containing alkaline or other non-acid electrolytes - Sealed nickel-cadmium prismatic rechargeable single cells
EN 61140:2016 Protection against electric shock - Common aspects for installation and equipment
EN 60529:1991/AC:2016-12 DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE) (IEC 60529 EDITION 2.2 CORRIGENDUM 2:2015)
EN 60896-22:2004 Stationary lead-acid batteries - Part 22: Valve regulated types - Requirements
IEC 61140:2016 Protection against electric shock - Common aspects for installation and equipment
IEC 60623:2017 Secondary cells and batteries containing alkaline or other non-acid electrolytes - Vented nickel-cadmium prismatic rechargeable single cells
IEC 60364-4-42:2010+AMD1:2014 CSV Low-voltage electrical installations - Part 4-42: Protection forsafety - Protection against thermal effects
IEC 60664-1:2007 Insulation coordination for equipment within low-voltage systems - Part 1: Principles, requirements and tests
EN 60896-21:2004 Stationary lead-acid batteries - Part 21: Valve regulated types - Methods of test
IEC 60990:2016 Methods of measurement of touch current and protective conductor current
IEC 60622:2002 Secondary cells and batteries containing alkaline or other non-acid electrolytes - Sealed nickel-cadmium prismatic rechargeable single cells

View more information
$105.88
Including GST where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more