Preview

ROAD VEHICLES - VEHICLE TO GRID COMMUNICATION INTERFACE - PART 3: PHYSICAL AND DATA LINK LAYER REQUIREMENTS (ISO 15118-3:2015)

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-01-2016

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National Foreword
European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Conventions
6 System architecture
7 Connection coordination
8 Timings and constants
9 Matching EV - EVSE process
10 EMC requirements
11 Signal coupling
12 Layer 2 interfaces
Annex A (normative) - HomePlug Green PHY on control
pilot line
Annex B (informative) - IEEE 1901.2 G3-PLC profile on
control pilot line
Bibliography

Defines the requirements of the physical and data link layer for a high-level communication, directly between battery electric vehicles (BEV) or plug-in hybrid electric vehicles (PHEV), termed as EV (electric vehicle) [ISO-1], based on a wired communication technology and the fixed electrical charging installation [Electric Vehicle Supply Equipment (EVSE)] used in addition to the basic signalling, as defined in [IEC-1].

DocumentType	Standard
Pages	96
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
EN ISO 15118-3:2016	Identical
ISO 15118-3:2015	Identical

IEC 62196-2:2016	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories
IEC TS 62763:2013	Pilot function through a control pilot circuit using PWM (pulse width modulation) and a control pilot wire
IEC 62196-3:2014	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility and interchangeability requirements for d.c. and a.c./d.c. pin and contact-tube vehicle couplers
ISO 15118-1:2013	Road vehicles Vehicle to grid communication interface Part 1: General information and use-case definition
ISO 15118-2:2014	Road vehicles Vehicle-to-Grid Communication Interface Part 2: Network and application protocol requirements
IEC 61851-1:2017	Electric vehicle conductive charging system - Part 1: General requirements
IEC 62196-1:2014	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements

View more information

$204.57

Including GST where applicable

Product format

I agree to the DRM document license rules apply against the PDF selection made.

Please confirm that you agree to the document license rules for this document.

I agree to the document license rules .

Please confirm that you agree to the document license rules for this document.

Access your standards online with a subscription

Features

Simple online access to standards, technical information and regulations.
Critical updates of standards and customisable alerts and notifications.
Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

Get in touch with us

I.S. EN ISO 15118-3:2016

ROAD VEHICLES - VEHICLE TO GRID COMMUNICATION INTERFACE - PART 3: PHYSICAL AND DATA LINK LAYER REQUIREMENTS (ISO 15118-3:2015)

Table of Contents

Abstract

General Product Information

International Equivalents

Standards Referencing This Book

Category

Subcategory