GAS CYLINDERS - ACETYLENE CYLINDERS - BASIC REQUIREMENTS AND TYPE TESTING (ISO 3807:2013, CORRECTED VERSION 2013-11-15)

Published date

01-01-2013

Publisher

National Standards Authority of Ireland

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Basic requirements
5 Type approval
6 Manufacturing of the porous material
7 Solvent-free acetylene cylinders
Annex A (normative) - Determination of the
        porosity of the porous material
Annex B (normative) - Determination of the
        compressive strength of monolithic porous
        materials
Annex C (normative) - Calculation of the
        working pressure
Annex D (normative) - Verification that development
        of hydraulic pressure is prevented
Annex E (normative) - Backfire test
Annex F (normative) - Fire test
Annex G (normative) - Testing of the integrity of
        the porous material in the area of joggle welds
Annex H (normative) - Test procedures for fusible
        plugs used in acetylene cylinders
Annex I (normative) - Inspection procedures for
        the manufacture of acetylene cylinders
Annex J (informative) - Explanation and examples
        for the calculation method according to D.3
Bibliography

Describes the basic and type testing requirements for acetylene cylinders with and without fusible plugs with a maximum nominal water capacity of 150 l and requirements regarding production/batch test procedures for manufacturing of acetylene cylinders with porous material.

DevelopmentNote	Supersedes I.S. EN 1800. (10/2013)
DocumentType	Standard
PublisherName	National Standards Authority of Ireland
Status	Current
Supersedes	I.S. EN 1800:2006

Standards	Relationship
ISO 3807:2013	Identical
EN ISO 3807:2013	Identical

CGA C 12 : 2014	QUALIFICATION PROCEDURE FOR ACETYLENE CYLINDER DESIGN
ISO 80000-4:2006	Quantities and units Part 4: Mechanics
ISO 9809-3:2010	Gas cylinders Refillable seamless steel gas cylinders Design, construction and testing Part 3: Normalized steel cylinders
ISO 4706:2008	Gas cylinders — Refillable welded steel cylinders — Test pressure 60 bar and below
ISO 7866:2012	Gas cylinders — Refillable seamless aluminium alloy gas cylinders — Design, construction and testing
ISO 10297:2014	Gas cylinders — Cylinder valves — Specification and type testing
ISO 10462:2013	Gas cylinders — Acetylene cylinders — Periodic inspection and maintenance
ISO 9809-1:2010	Gas cylinders Refillable seamless steel gas cylinders Design, construction and testing Part 1: Quenched and tempered steel cylinders with tensile strength less than 1 100 MPa
ISO 11117:2008	Gas cylinders Valve protection caps and valve guards Design, construction and tests
ISO 13769:2007	Gas cylinders Stamp marking
ISO 11372:2011	Gas cylinders — Acetylene cylinders — Filling conditions and filling inspection
ISO 13088:2011	Gas cylinders — Acetylene cylinder bundles — Filling conditions and filling inspection
ISO 3893:1977	Concrete — Classification by compressive strength