PREN 12680-1 : DRAFT 2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
FOUNDING - ULTRASONIC INSPECTION - PART 1: STEEL CASTING FOR GENERAL PURPOSES
01-01-2003
12-01-2013
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
4.1 Order information
4.2 Extent of testing
4.3 Maximum permissible size of discontinuities
4.4 Testing personnel
4.5 Wall section zones
4.6 Severity levels
5 Test method
5.1 Principles
5.2 Material
5.3 Equipment, coupling medium and time-base calibration
5.4 Preparation of casting surfaces for testing
5.5 Test procedure
5.6 Test report
Table 1 - Acceptance limits for non-planar discontinuities
Table 2 - Ultrasonic testability requirements
Table 3 - Recording levels
Figure 1 - Acceptance limits for individual planar indications
mainly orientated in through-wall direction, detected
with angle probes
Figure 2 - Division of wall section into zones
Figure 3 - Measurement of the dimension of discontinuities in
through-wall direction
Figure 4 - Measurement of the dimensions of discontinuities in
through-wall direction with normal probes
Annex A (informative) Sound-beam diameters
Annex B (informative) Types of indications
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.