We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • SAE AMS 4025 : 2014

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You have already added this standard to your Watchlist.
    Visit My Watchlist to view the full list.

    ALUMINUM ALLOY, SHEET AND PLATE, 1.0MG - 0.60SI - 0.28CU - 0.20CR (6061-O) ANNEALED

    Available format(s):  Hardcopy, PDF

    Superseded date:  17-07-2020

    Language(s):  English

    Published date:  01-01-2014

    Publisher:  SAE International

    Add to Watchlist

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    1. SCOPE
    2. APPLICABLE DOCUMENTS
    3. TECHNICAL REQUIREMENTS
    4. QUALITY ASSURANCE PROVISIONS
    5. PREPARATION FOR DELIVERY
    6. ACKNOWLEDGMENT
    7. REJECTIONS
    8. NOTES

    Abstract - (Show below) - (Hide below)

    Specifies an aluminum alloy in the form of sheet and plate from 0.006 to 3.000 inches (0.15 to 76.20 mm) in thickness, inclusive.

    General Product Information - (Show below) - (Hide below)

    Committee AMS-D
    Development Note Supersedes SAE AMS QQ A 250/11. (07/2008)
    Document Type Revision
    Publisher SAE International
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    MIL DTL 28754 : E CONNECTORS, ELECTRICAL, MODULAR, AND COMPONENT PARTS GENERAL SPECIFICATION FOR
    SAE AMS 1551 : 2008 CLEANER, TURBINE ENGINE GAS PATH AQUEOUS TYPE
    SAE AMS 1548 : 2017 CLEANER, TURBINE ENGINE GAS PATH, SOLVENT EMULSION TYPE

    Standards Referencing This Book - (Show below) - (Hide below)

    ANSI H35.2 : 2017 DIMENSIONAL TOLERANCES FOR ALUMINUM MILL PRODUCTS
    ASTM B 666/B666M : 2015 : REDLINE Standard Practice for Identification Marking of Aluminum and Magnesium Products
    SAE AMS 2772 : 2016 HEAT TREATMENT OF ALUMINUM ALLOY RAW MATERIALS
    SAE AS 1990 : 2016 ALUMINUM ALLOY TEMPERS
    SAE AMS 2355 : 2016 QUALITY ASSURANCE, SAMPLING AND TESTING, ALUMINUM ALLOYS AND MAGNESIUM ALLOY, WROUGHT PRODUCTS (EXCEPT FORGING STOCK), AND ROLLED, FORGED, OR FLASH WELDED RINGS
    ASTM B 660 : 2015 : REDLINE Standard Practices for Packaging/Packing of Aluminum and Magnesium Products
    ANSI H35.2M : 2013 DIMENSIONAL TOLERANCES FOR ALUMINUM MILL PRODUCTS (METRIC)
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective