UNI ISO 12151-3 : 2012

Name: UNI ISO 12151-3 : 2012
Brand: UNI

Superseded

View Superseded by

CONNECTIONS FOR HYDRAULIC FLUID POWER AND GENERAL USE - HOSE FITTINGS - PART 3: HOSE FITTINGS WITH ISO 6162-1 OR ISO 6162-2 FLANGE ENDS

Superseded date

18-01-2023

Published date

07-06-2012

Publisher

Ente Nazionale Italiano di Unificazione (UNI)

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Performance requirements
5 Designation of hose fittings
6 Design
7 Manufacture
8 Procurement information
9 Marking
10 Identification statement (reference to this
part of ISO 12151)
Bibliography

Describes the general and dimensional requirements for the design and performance of flange hose fittings, made of carbon steel, for nominal hose inside diameters of 12,5 mm to 51 mm inclusive, in accordance with ISO 4397, for use with ports and clamps in accordance with ISO 6162-1 and ISO 6162-2.

Committee	CT 48
DocumentType	Standard
PublisherName	Ente Nazionale Italiano di Unificazione (UNI)
Status	Superseded
SupersededBy	UNI ISO 12151-3:2023
Supersedes	UNI ISO 12151-3 : 2005

Standards	Relationship
ISO 12151-3:2010	Identical

ISO 4039-1:1998	Road vehicles — Pneumatic braking systems — Part 1: Pipes, male fittings and tapped holes with facial sealing surface
ISO 3862:2017	Rubber hoses and hose assemblies Rubber-covered spiral-wire-reinforced hydraulic types for oil-based or water-based fluids Specification
ISO 3949:2009	Plastics hoses and hose assemblies Textile-reinforced types for hydraulic applications Specification
ISO 5598:2008	Fluid power systems and components Vocabulary
ISO 6605:2017	Hydraulic fluid power — Test methods for hoses and hose assemblies
ISO 4397:2011	Fluid power connectors and associated components — Nominal outside diameters of tubes and nominal hose sizes
ISO 4039-2:1998	Road vehicles Pneumatic braking systems Part 2: Pipes, male fittings and holes with conical sealing surface
ISO 6162-2:2012	Hydraulic fluid power Flange connections with split or one-piece flange clamps and metric or inch screws Part 2: Flange connectors, ports and mounting surfaces for use at a pressure of 42 MPa (420 bar), DN 13 to DN 76
ISO 4038:1996	Road vehicles — Hydraulic braking systems — Simple flare pipes, tapped holes, male fittings and hose end fittings
ISO 4079:2017	Rubber hoses and hose assemblies Textile-reinforced hydraulic types for oil-based or water-based fluids Specification
ISO 6162-1:2012	Hydraulic fluid power — Flange connections with split or one-piece flange clamps and metric or inch screws — Part 1: Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127
ISO 19879:2010	Metallic tube connections for fluid power and general use Test methods for hydraulic fluid power connections
ISO 9227:2017	Corrosion tests in artificial atmospheres — Salt spray tests
ISO 1436:2017	Rubber hoses and hose assemblies Wire-braid-reinforced hydraulic types for oil-based or water-based fluids Specification