Name: UNI ISO 12151-6 : 2012
Brand: UNI

CONNECTIONS FOR HYDRAULIC FLUID POWER AND GENERAL USE - HOSE FITTINGS - PART 6: HOSE FITTINGS WITH ISO 8434-6 60 DEGREE CONE ENDS

Published date

07-06-2012

Publisher

Ente Nazionale Italiano di Unificazione (UNI)

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Performance requirements
5 Designation of hose fittings
6 Design
7 Manufacture
8 Assembly instructions
9 Procurement information
10 Marking
11 Identification statement (reference to this part of ISO 12151)
Bibliography

Defines the general and dimensional requirements for the design and performance of hose fittings made of carbon steel with 60 Degree cone ends for hose sizes 5 to 51 inclusive, in accordance with ISO 4397.

Committee	CT 48
DocumentType	Standard
PublisherName	Ente Nazionale Italiano di Unificazione (UNI)
Status	Current

Standards	Relationship
ISO 12151-6:2009	Identical

ISO 4079-1:2001	Rubber hoses and hose assemblies Textile-reinforced hydraulic types Specification Part 1: Oil-based fluid applications
ISO 4039-1:1998	Road vehicles — Pneumatic braking systems — Part 1: Pipes, male fittings and tapped holes with facial sealing surface
ISO 3949:2009	Plastics hoses and hose assemblies Textile-reinforced types for hydraulic applications Specification
ISO 5598:2008	Fluid power systems and components Vocabulary
ISO 4759-1:2000	Tolerances for fasteners — Part 1: Bolts, screws, studs and nuts — Product grades A, B and C
ISO 6605:2017	Hydraulic fluid power — Test methods for hoses and hose assemblies
ISO 4397:2011	Fluid power connectors and associated components — Nominal outside diameters of tubes and nominal hose sizes
ISO 4039-2:1998	Road vehicles Pneumatic braking systems Part 2: Pipes, male fittings and holes with conical sealing surface
ISO 4038:1996	Road vehicles — Hydraulic braking systems — Simple flare pipes, tapped holes, male fittings and hose end fittings
ISO 1436-1:2001	Rubber hoses and hose assemblies Wire-braid-reinforced hydraulic types Specification Part 1: Oil-based fluid applications
ISO 19879:2010	Metallic tube connections for fluid power and general use Test methods for hydraulic fluid power connections
ISO 8434-6:2009	Metallic tube connections for fluid power and general use — Part 6: 60 degree cone connectors with or without O-ring
ISO 6149-1:2006	Connections for hydraulic fluid power and general use Ports and stud ends with ISO 261 metric threads and O-ring sealing Part 1: Ports with truncated housing for O-ring seal
ISO 9227:2017	Corrosion tests in artificial atmospheres — Salt spray tests
ISO 3862-1:2001	Rubber hoses and hose assemblies Rubber-covered spiral-wire-reinforced hydraulic types Specification Part 1: Oil-based fluid applications
ISO 228-1:2000	Pipe threads where pressure-tight joints are not made on the threads Part 1: Dimensions, tolerances and designation