11/30235982 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
31-07-2014
English
Foreword
Introduction
1 Scope
2 Normative References
3 Terms and definitions
4 General clothing design
5 Sampling and pre-treatment
6 Physical Requirements
7 Marking
8 Information supplied by the manufacturer
Annex A (normative) - Uncertainty of measurement
Annex B (informative) - Significant technical changes
between this document and the previous
edition EN 469:2005
Annex ZA (informative) - Relationship between this
European Standard and the Essential
Requirements of EU Directive 89/686/EEC
Bibliography
BS EN 469
Committee |
PH/3/2
|
DocumentType |
Draft
|
Pages |
25
|
PublisherName |
British Standards Institution
|
Status |
Superseded
|
SupersededBy |
Standards | Relationship |
PREN 469 : DRAFT 2015 | Identical |
EN 943-1:2015 | Protective clothing against dangerous solid, liquid and gaseous chemicals, including liquid and solid aerosols - Part 1: Performance requirements for Type 1 (gas-tight) chemical protective suits |
ISO 13934-1:2013 | Textiles — Tensile properties of fabrics — Part 1: Determination of maximum force and elongation at maximum force using the strip method |
ISO 13988:2008 | Passenger vehicle wheels — Clip balance weight and rim flange nomenclature, test procedures and performance requirements |
EN 943-2:2002 | Protective clothing against liquid and gaseous chemicals, including liquid aerosols and solid particles - Part 2: Performance requirements for "gas-tight" (Type 1) chemical protective suits for emergency teams (ET) |
EN ISO 1421:2016 | Rubber- or plastics-coated fabrics - Determination of tensile strength and elongation at break (ISO 1421:2016) |
ISO 3175-2:2010 | Textiles Professional care, drycleaning and wetcleaning of fabrics and garments Part 2: Procedure for testing performance when cleaning and finishing using tetrachloroethene |
EN ISO 13937-2 : 2000 | TEXTILES - TEAR PROPERTIES OF FABRICS - PART 2: DETERMINATION OF TEAR FORCE OF TROUSER-SHAPED TEST SPECIMENS (SINGLE TEAR METHOD) (ISO 13937-2:2000) |
ISO 6530:2005 | Protective clothing — Protection against liquid chemicals — Test method for resistance of materials to penetration by liquids |
EN 1082-3:2000 | Protective clothing - Gloves and arm guards protecting against cuts and stabs by hand knives - Part 3: Impact cut test for fabric, leather and other materials |
EN 20811 : 1992 | TEXTILES - DETERMINATION OF RESISTANCE TO WATER PENETRATION - HYDROSTATIC PRESSURE TEST |
EN ISO 13934-1:2013 | Textiles - Tensile properties of fabrics - Part 1: Determination of maximum force and elongation at maximum force using the strip method (ISO 13934-1:2013) |
CEN/TR 14560:2003 | Guidance for selection, use, care and maintenance of protective clothing against heat and flame |
ISO 6330:2012 | Textiles Domestic washing and drying procedures for textile testing |
EN ISO 14116:2015 | Protective clothing - Protection against flame - Limited flame spread materials, material assemblies and clothing (ISO 14116:2015) |
EN 1149-1:2006 | Protective clothing - Electrostatic properties - Part 1: Test method for measurement of surface resistivity |
ISO 6942:2002 | Protective clothing — Protection against heat and fire — Method of test: Evaluation of materials and material assemblies when exposed to a source of radiant heat |
EN ISO 13998:2003 | Protective clothing - Aprons, trousers and vests protecting against cuts and stabs by hand knives (ISO 13998:2003) |
ISO 14116:2015 | Protective clothing — Protection against flame — Limited flame spread materials, material assemblies and clothing |
ISO 15538:2001 | Protective clothing for firefighters — Laboratory test methods and performance requirements for protective clothing with a reflective outer surface |
EN 863:1995 | Protective clothing - Mechanical properties - Test method: Puncture resistance |
EN ISO 14460:1999/A1:2002 | PROTECTIVE CLOTHING FOR AUTOMOBILE RACING DRIVERS - PROTECTION AGAINST HEAT AND FLAME - PERFORMANCE REQUIREMENTS AND TEST METHODS |
EN 136:1998/AC:2003 | RESPIRATORY PROTECTIVE DEVICES - FULL-FACE MASKS - REQUIREMENTS, TESTING, MARKING |
EN ISO 5077:2008 | Textiles - Determination of dimensional change in washing and drying (ISO 5077:2007) |
ISO 15025:2016 | Protective clothing Protection against flame Method of test for limited flame spread |
ISO 15384:2003 | Protective clothing for firefighters Laboratory test methods and performance requirements for wildland firefighting clothing |
EN ISO 4674-1:2016 | Rubber- or plastics-coated fabrics - Determination of tear resistance - Part 1: Constant rate of tear methods (ISO 4674-1:2016) |
ISO 17493:2016 | Clothing and equipment for protection against heat Test method for convective heat resistance using a hot air circulating oven |
EN ISO 6530:2005 | Protective clothing - Protection against liquid chemicals - Test method for resistance of materials to penetration by liquids (ISO 6530:2005) |
ISO 14460:1999 | Protective clothing for automobile racing drivers — Protection against heat and flame — Performance requirements and test methods |
EN 471:2003+A1:2007 | High-visibility warning clothing for professional use - Test methods and requirements |
ISO 7933:2004 | Ergonomics of the thermal environment — Analytical determination and interpretation of heat stress using calculation of the predicted heat strain |
EN 1149-2:1997 | Protective clothing - Electrostatic properties - Part 2: Test method for measurement of the electrical resistance through a material (vertical resistance) |
ISO 11092:2014 | Textiles — Physiological effects — Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded-hotplate test) |
EN 13911:2017 | Protective clothing for firefighters - Requirements and test methods for fire hoods for firefighters |
EN ISO 7933:2004 | Ergonomics of the thermal environment - Analytical determination and interpretation of heat stress using calculation of the predicted heat strain (ISO 7933:2004) |
EN 31092:1993/A1:2012 | TEXTILES - DETERMINATION OF PHYSIOLOGICAL PROPERTIES - MEASUREMENT OF THERMAL AND WATER-VAPOUR RESISTANCE UNDER STEADY-STATE CONDITIONS (SWEATING GUARDED - HOTPLATE TEST) (ISO 11092:1993/AMD 1:2012) |
EN ISO 15025:2016 | Protective clothing - Protection against flame - Method of test for limited flame spread (ISO 15025:2016) |
EN 340:2003 | Protective clothing - General requirements |
EN 137:2006 | Respiratory protective devices - Self-contained open-circuit compressed air breathing apparatus with full face mask - Requirements, testing, marking |
ISO 1421:2016 | Rubber- or plastics-coated fabrics — Determination of tensile strength and elongation at break |
EN 367:1992/AC:1992 | PROTECTIVE CLOTHING - PROTECTION AGAINST HEAT AND FIRE - METHOD OF DETERMINING HEAT TRANSMISSION ON EXPOSURE TO FLAME |
ISO 7000:2014 | Graphical symbols for use on equipment Registered symbols |
EN 1486:2007 | Protective clothing for fire-fighters - Test methods and requirements for reflective clothing for specialised fire-fighting |
EN 531:1995/A1:1998 | PROTECTIVE CLOTHING FOR INDUSTRIAL WORKERS EXPOSED TO HEAT |
ISO 4674-1:2016 | Rubber- or plastics-coated fabrics Determination of tear resistance Part 1: Constant rate of tear methods |
ISO 9886:2004 | Ergonomics Evaluation of thermal strain by physiological measurements |
EN ISO 6330:2012 | Textiles - Domestic washing and drying procedures for textile testing (ISO 6330:2012) |
EN 2419920 : 1992 | TEXTILES - DETERMINATION OF RESISTANCE TO SURFACE WETTING (SPRAY TEST) OF FABRICS |
EN ISO 6942:2002 | Protective clothing - Protection against heat and fire - Method of test: Evaluation of materials and material assemblies when exposed to a source of radiant heat (ISO 6942:2002) |
EN ISO 9886:2004 | Ergonomics - Evaluation of thermal strain by physiological measurements (ISO 9886:2004) |
ISO 13506:2008 | Protective clothing against heat and flame Test method for complete garments Prediction of burn injury using an instrumented manikin |
EN 1149-3:2004 | Protective clothing - Electrostatic properties - Part 3: Test methods for measurement of charge decay |
CLC/TS 50354:2003 | Electrical arc test methods for material and garments, for use by workers at risk from exposure to an electrical arc |
ISO 11613:1999 | Protective clothing for firefighters Laboratory test methods and performance requirements |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.