11/30249851 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
30-04-2013
English
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Limit states design
6 Partial load and safety factors for loads and
resistances
7 Static design procedures
8 Design member forces
9 Design criteria
10 Design resistance of uniplanar CHS braces
to CHS chord joints
11 Design resistance of uniplanar gusset plates,
I or H section braces or RHS braces to
CHS chord joints
12 Design resistance of multiplanar joints with
CHS chord
13 Design resistance of uniplanar RHS braces or
CHS braces to RHS chord joints
14 Design resistance of uniplanar SHS or CHS
braces to SHS chord joints
15 Design resistance of uniplanar gusset plate
to RHS joints
16 Design resistance of multiplanar joints with
RHS chord
17 Design resistance of uniplanar CHS or RHS
braces to I or H section chord joints
18 Design resistance of uniplanar overlap joints
with a CHS, RHS, I or H section chord
Annex A (normative) - Quality requirements for
hollow sections
Annex B (normative) - Weld details
Annex C (informative) - Partial safety factors on
static strength
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.