1 - AS 3785.6-1992 UNDERGROUND MINING-SHAFT EQUIPMENT - GUIDES AND RUBBING ROPES FOR CONVEYANCES
4 - PREFACE
4 - CONTENTS
5 - FOREWORD
6 - 1 SCOPE
6 - 2 REFERENCED DOCUMENTS
6 - 3 DEFINITIONS
6 - 3.1 Approved and approval
6 - 3.2 Bunton/dividers
6 - 3.3 Chairing
6 - 3.4 Conveyance
6 - 3.5 Conveyance guide assemblies
6 - 3.6 Dead loads
6 - 3.7 Gripper system
6 - 3.8 Guides
6 - 3.9 Live load
6 - 3.10 Overwind
6 - 3.11 Rope break force
6 - 3.12 Rubbing ropes
6 - 3.13 Shall
6 - 3.14 Should
7 - 3.15 Statutory authority
7 - 4 MATERIALS
7 - 4.1 General
7 - 4.2 Rigid steel guides
7 - 4.3 Rigid timber guides
7 - 4.4 Wire rope guides and rubbing ropes
7 - 4.5 Rope suspension glands
7 - 5 STRUCTURAL DESIGN
7 - 5.1 Loads
8 - 5.2 Design load combinations
8 - 5.2.1 Rigid guides
8 - 5.2.2 Rope guides and rubbing ropes
8 - 5.3 Design requirements
8 - 5.3.1 Rigid guide deflection
8 - 5.3.2 Rigid guide stresses
8 - 5.3.3 Rope guides and rubbing ropes
8 - 5.3.4 Rope suspension glands
8 - 6 CONSTRUCTION DESIGN
8 - 6.1 General
8 - 6.1.1 Corrosion/wear allowance
8 - 6.1.2 Shaft clearances
8 - 6.2 Rigid guide alignment
8 - 6.2.1 Adjustment
9 - 6.2.2 Skrinkage-timber guides
9 - 6.2.3 Thermal expansion-steel guide
9 - 6.2.4 Splices
9 - 6.2.5 Hydrostatic pressure
9 - 6.3 Rigid guide stiffness
9 - 6.4 Rope guides and rubbing ropes
9 - 6.4.1 Construction and sizing
9 - 6.4.2 Tensioning
9 - 6.4.3 Suspension method
9 - 7 MANUFACTURE
9 - 7.1 Steel guides
9 - 7.1.1 Manufacture
10 - 7.1.2 Tolerances
10 - 7.2 Timber guide
10 - 7.2.1 Manufacture
10 - 7.2.2 Tolerances
10 - 7.3 Rope guides and rubbing ropes:
11 - APPENDIX A - TYPICAL GUIDE LOAD DETERMINATION METHODS FOR RIGID GUIDES
11 - A1 GENERAL
11 - A2 TOLERANCES
11 - A3 LOADING