We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • AS B213-1966

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    Involute splines

    Available format(s):  Hardcopy, PDF 1 User, PDF 3 Users, PDF 5 Users, PDF 9 Users

    Superseded date:  23-06-2021

    Language(s):  English

    Published date:  01-01-1966

    Publisher:  Standards Australia

    Add to Watchlist

    Add To Cart

    Abstract - (Show below) - (Hide below)

    Specifies dimensions of involute splined shafts and holes with a 30 degrees pressure angle. Basic formulas for calculating dimensions and tolerances are included, with guidance on obtaining the fit desired. Terms used are defined. The Standard also describes methods of gauging and inspecting splines, with methods of obtaining dimensions and tolerances for gauges. Inspection of splines using pins is covered and tables of measurements over and between pins are included.

    Scope - (Show below) - (Hide below)

    This British Standard provides data and guidance for the design of straight involute splines of 30 pressure angle, tabulates limiting dimensions and deals with manufacturing errors and their effect on the fit between mating spline elements.The range of splines covered is:Side fit, 2.5/5 to 32/64 pitch, flat root 6 to 60 splines inclusive Major diameter fit, 3/6 to 16/32 pitch, flat root 6 to 60 splines inclusive Side fit, 2.5/5 to 48/96 pitch, fillet root 6 to 60 splines inclusive (see figure 1)

    General Product Information - (Show below) - (Hide below)

    Committee ME-011
    Document Type Standard
    Publisher Standards Australia
    Status Superseded
    Supersedes
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective